Yamaha htr-5890 Starting the setup, then, Subwoofer, PREPARATION, DISTANCE, SIZE, EQUALIZING or LEVEL, 1Switch on this unit and video monitor

Starting the setup

For best results, make sure the room is as quiet as possible during the auto setup procedure (YPAO). If there is too much ambient noise, the results may not be satisfactory.

y

If your subwoofer can adjust the output volume and the crossover frequency, set the volume to about half way (or slightly less) and set the crossover frequency to the maximum.

		CROSSOVER/
VOLUME		HIGH CUT
MIN	MAX	MIN	MAX

Subwoofer1Switch on this unit and video monitor.

Make sure the OSD is displayed (see page 50).

2Set AMP/SOURCE/TV to AMP, then press SET MENU to enter the SET MENU.

AMP	then	SET MENU
		MENU
SOURCE
TV

3Press k / n to select AUTO SETUP, then press h once to enter the main menu.

ENTER

SET MENU

. ;AUTO SETUP ;MANUAL SETUP

p/p	:	Up/Down
</>	:	Enter

ENTER

AUTO SETUP

4Press k / n repeatedly to select WIRING,DISTANCE, SIZE, EQUALIZING or LEVEL.

1 AUTO:MENU

.
WIRING;;;;;CHECK

DISTANCE;;;CHECK

SIZE;;;;;;;CHECK

EQUALIZING;;FLAT

LEVEL;;;;;;CHECK

SETUP;;;;;;;AUTO


START PUSH >

p/p	:	Up/Down
</>	:	Select

5When WIRING, DISTANCE, SIZE or LEVEL is selected, press l / h to select:

CHECK To automatically check and adjust the selected item.

SKIP To skip the selected item and perform no adjustments.

Note

When using THX speakers, set SIZE to SKIP and make sure that “SMALL” or “SMLx2” is selected in SPEAKER SET (page 55) and that 80Hz (THX) is selected in CROSS OVER (page 57).

When EQUALIZING is selected, press l / h to select:

FRONT To adjust the frequency response of each speaker in accordance with the sound of your front speakers.

Recommended if your front speakers are of much higher quality than your other speakers.

FLAT	To average the frequency response of
	all speakers. Recommended if all of
	your speakers are of similar quality.
LOW	To average the frequency response of
	all speakers, giving priority to the
	accuracy of bass frequencies.
MID	To average the frequency response of
	all speakers, giving priority to the
	accuracy of mid-range frequencies.
HIGH	To average the frequency response of
	all speakers, giving priority to the
	accuracy of high frequencies.
SKIP	To skip the selected item and perform
	no adjustments.

6Press nto select SETUP, then press l/ hto select:

AUTO	To automatically perform the entire
	auto setup procedure.
STEP	To pause for confirmation between
	each check in the auto setup procedure.
RELOAD	To restore the last auto setup setting.

PREPARATION

27