Yamaha htr-5890 Code, Function, ADVANCED, OPERATION, 4Press ENTER, 6Press ENTER to set the number, 7Press LEARN again to exit from the setup mode

2Press an input selector button to select the source component you want to set up.

A	B	INPUT MODE	SLEEP
PHONO	TUNER	CD	MULTI CH IN
V-AUX	CBL/SAT	MD/TAPE	CD-R
DTV	VCR 1	DVR/VCR2	DVD

3Press and hold LEARN for about 3 seconds using a ballpoint pen or similar object.

The library name (ex. “L:DVD”) and the selected component name (ex. “DVD”) appear alternately in the display window.

LEARN

If you want to setup for another component, press the input selector button or SELECT k/n to select the component.

Notes

•Be sure to press and hold LEARN for at least 3 seconds, otherwise the learning process will start.

•If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, press LEARN again.

If you want to change a library (component category), press l / h. You can set a different type of component.

Library choices: L:DVD, L:DVR, L:LD, L:CD, L:CDR, L:MD, L:TAP (tape), L:TUN (tuner), L:AMP*, L:TV, L:CAB (cable), L:SAT (satellite), L:VCR

*The amplifier library (L:AMP) code is preset to “AMP1” (2000) in order to operate this unit. However, you can switch by entering one of the following five codes if necessary.

	Function	Code

AMP1	To operate this unit.	2000

AMP1Z	To operate ZONE 2 or ZONE 3	2001
AMP1Z	features.	2001
	features.

NO	To operate other manufacturers’	2004
NO	receivers / amplifiers using this	2004
	unit’s remote control

REMOTE CONTROL FEATURES

4Press ENTER.

The four-digit code set for the selected component appears in the display window.

Note

“0000” appears in the display window if no code has been set.

5Press the numeric buttons to enter the four- digit remote control code for the component you want to use.

For a complete list of available remote control codes, refer to “LIST OF REMOTE CONTROL CODES” at the end of this manual.

STEREO	HALL	JAZZ	ROCK
1	2	3	4
ENTERTAIN	MUSIC	THTR	MOVIE
5	6	7	8
THX	STANDARD		EXTD. SUR
9	0	+10	ENT.

6Press ENTER to set the number.

“OK” appears in the display window if setting was successful.

“NG” appears in the display window if the setting was unsuccessful. In this case, start over from step 3.

If you continuously want to set up another code for another component, press the input selector button or SELECT k/n to select the component, then repeat steps 4 through 6.

7Press LEARN again to exit from the setup mode.

LEARN

OPERATION	ADVANCED