Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to “6Ω MIN” as follows BEFORE using this unit.
1Press A STANDBY/ON on the front panel to set this unit to the standby mode.
Refer to the right column for details.
2Press and hold K TONE CONTROL and then press A STANDBY/ON to turn on this
unit.
This unit turns on, and the advanced setup menu appears in the front panel display.
While holding
TONE CONTROL | down |
|
| STANDBY | |
|
| /ON |
Connections
Turning on and off the power
■Turning on this unit
Press A STANDBY/ON (or HPOWER) to turn on this unit.
y
When you turn on this unit, there will be a 4 to
■Set this unit to the standby mode
Press A STANDBY/ON (or ISTANDBY) to set
this unit to the standby mode.
In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.
PREPARATION
3Press L PROGRAM l / h to select “SP
IMP.”.
“SP IMP.” and the current speaker impedance setting (“8Ω MIN”) appear in the front panel display.
4Press M STRAIGHT repeatedly to select “6Ω MIN”.
5Press A STANDBY/ON to save the new setting and turn off this unit.
Note
The setting you made is reflected next time you turn on this unit.
English
