Yamaha MG24/14 FX, MG32/14 FX

Front & Rear Panels

MG32/14FX, MG24/14FX

■GROUP Section

This section adjusts the level and controls the ﬂow of the signals

from the four GROUP buses. While the signal from each GROUP

bus is always fed into the corresponding GROUP OUT jack (see

page 20), you are also free to use the TO ST and AFL switches to

selectively feed these groups into the ST and AFL buses.

1PAN Control

If you are feeding the signal from the GROUP bus into the ST

bus (that is, if the corresponding TO ST switch (2) is on), this

knob controls how the signal is positioned on the ST L/R lines.

2TO ST Switches

For each group: If the switch is on ( ), the mixer feeds the

signal from the GROUP bus into the ST bus, after ﬁrst passing

the signal through the GROUP fader (4) and the PAN control

(1).

3AFL (After-Fader Listen) Switches

Feeds the corresponding GROUP OUT signal into the AFL

bus, so that this signal can be monitored at the PHONES jack.

4Group Faders

Each fader adjusts the level of the signal that is fed to the corre-

sponding GROUP OUT jack.

■SEND Section

This section adjusts the levels and controls the ﬂow of the signals

from the six AUX buses and the two EFFECT buses. Each of these

signals ﬂows to the corresponding SEND output jack (to

AUX1–AUX6, EFF1, and EFF2, respectively).

1AUX Controls (AUX1 to AUX6)

Each knob adjusts the level of the signal from the indicated

AUX bus into the corresponding AUX SEND jack.

2Effect Controls (EFF1, EFF2)

Each knob adjusts the level of the signal from the indicated

EFFECT bus into the corresponding EFFECT SEND jack and

also into the corresponding internal digital effect.

For each channel, you use the channel’s AUX5/6

switch (see page 11) to select between feed into the

AUX5 and 6 buses or feed into the EFFECT 1 and 2

buses. If the switch is on ( ), the signal goes to

the AUX5 and AUX6 SEND jacks. If the switch is off

( ), the signal goes to the EFF1 and EFF2 SEND

jacks.

3AFL (After-Fader Listen) Switches

For each AUX and EFFECT bus: Use this switch to feed the

corresponding AUX SEND or EFF SEND signal into the AFL

bus. Feeds the corresponding AUX SEND or EFF SEND signal

into the AFL bus, so that this signal can be monitored at the

PHONES jack.

If you set this switch on for EFF1 or EFF2, you can

use the PHONES jack to monitor the signal to the

corresponding internal digital effect.

NOTE

MG32-14FX_E.book Page 14 Thursday, June 12, 2003 3:10 PM