Front & Rear Panels
MG32/14FX, MG24/14FX
16
■INTERNAL DIGITAL EFFECTS Section
You use this section to control the dual internal effects processor: to
select the two effect types, to set the effects on or off, and to adjust
the related signal levels and flows.
1PROGRAM Dials
This dial sets the effect type for the corresponding internal dig-
ital effect. For information about the effect types, see page 24.
2PARAMETER Controls
This knob sets the parameter value for the corresponding inter-
nal digital effect. The setting applies to the currently selected
effect type.
The mixer saves the last value used with each effect
type. When you change to a different effect type, the
mixer automatically restores the value that was pre-
viously used with the newly selected effect (regard-
less of the current position of the Parameter Control
knob). These parameter values are retained even
after power-off.
3AUX PRE Controls (1 to 4)
Each knob adjusts the level of the effected sound into the corre-
sponding AUX bus (AUX1 to AUX4).
4TAP Button and Indicator
This feature lets you set the delay time for internal EFFECT 2
by tapping on the button. The feature only works if you have
set the effect type for EFFECT 2 to [16] TAP DELAY. To set
the delay time, tap on the button at the appropriate interval. The
mixer measures the interval between the last two taps and sets
this as the delay time. Continue tapping as necessary until you
get the timing right.
The mixer retains the last time setting even after power goes
off, and restores this setting the next time you set the effect
type to TAP DELAY. The indicator next to the button flashes in
sync with the delay time.
5ON Switches
This switch turns the corresponding internal digital effect on
( ) or off ( ).
6PFL (Pre-Fader Listen) Switches
Use this switch to feed the corresponding digital effect signal,
taken from before the EFFECT RTN fader, into the PFL bus, so
that you can monitor the signal from the PHONES jack. To
turn the PFL feed on, press the switch in ( ).
The signal will not feed into the PFL bus if the
effect’s ON switch (5) is turned off.
7GROUP Switches
Set the switch on ( ) to feed the corresponding internal digi-
tal effect signal into the corresponding GROUP buses. The top
button feeds the signal to Groups 1 and 2; the lower button
feeds it to Groups 3 and 4.
8ST Switches
Set this switch on to feed the corresponding internal digital
effect signal into the ST bus.
9EFFECT RTN faders (1, 2)
This fader adjusts the level of the effected sound into the ST
and GROUP buses.
1
5
6
7
8
2
3
4
9
NOTE
NOTE
MG32-14FX_E.book Page 16 Thursday, June 12, 2003 3:10 PM