Front & Rear Panels
MG32/14FX, MG24/14FX 17■METER/PHONES Section
You use these meters to view various signal levels: the levels to the
ST OUT jacks, the PFL and AFL levels, and the levels to the
GROUP OUT jacks. The PFL or AFL signals indicated by these
meters can be monitored through the PHONES jack.
1POWER Indicator
Lights up when the mixer’s power is on.
2STEREO Level Meters
If the GROUP switch (4) is off, the left and right meters show
the level to the ST OUT L and R jacks, respectively. If the
GROUP switch is on, the left and right meters show the level to
GROUP OUT jacks 1 and 2, respectively. The “0” position cor-
responds to the standard level. The PEAK indicator lights up
red when the level hits the clipping point.
3PFL-AFL Level Meters
If the GROUP switch (4) is off, these meters show the levels
to the PHONES jack. If the GROUP switch is on, the left meter
shows the level to GROUP OUT jack 3 and the right meter
shows the level to GROUP OUT jack 4. The “0” position corre-
sponds to the standard level. The PEAK indicator comes on red
when the level hits the clipping point.
If signals are present on both the PFL and AFL
buses, the PHONES jack will output the PFL signal
only. Accordingly, these meters will indicate only the
PFL level.
4GROUP Switch
Selects whether the meters show the GROUP levels or the ST
and PFL/AFL levels. If the switch is on ( ), the four meters
show the levels to GROUP OUT jacks 1 to 4, in order. If the
switch is off ( ), the meters operate as described above.
5PHONES Jack and Control
• PHONES Jack
An unbalanced stereo phone output jack, for connection to
headphones.
• PHONES Control
Controls the level of the signal output to the PHONES jack
for monitoring.
The PFL-AFL level meter (3) shows the level of the
signal monitored through the PHONES jack.
■2TR INPUT Section
This section adjusts the signal that is input from the 2TR IN jack
(see page 20).
12TR IN Control
Adjusts the level of the signal from the 2TR IN jack into the ST
bus.
2PFL (Pre-Fader Listen) Switch
Use this switch to feed the signal from the 2TR IN jack, taken
from before the 2TR IN control, into the PFL bus, so that you
can monitor the signal from the PHONES jack. To turn the PFL
feed on, press the switch in ( ).
3
4
2
1
5
NOTE
NOTE
1
2
MG32-14FX_E.book Page 17 Thursday, June 12, 2003 3:10 PM