Front & Rear Panels
MG32/14FX, MG24/14FX 15
■RETURN Section
This section adjusts the levels of the input from the RETURN 1 and
RETURN 2 jacks (see page 20). For each RETURN, you can set
independent levels for feeds into the ST bus and AUX buses 1 to 4.
1AUX Mix Controls (1 to 4)
Each knob adjusts the level of the signal from the correspond-
ing RETURN jack into the corresponding AUX bus (AUX1 to
AUX4). If you are inputting a stereo signal, the L and R signals
are mixed before moving to the AUX buses.
2ST Control
Adjusts the level of the signal from the corresponding
RETURN jack into the ST bus. If you are inputting a stereo
signal, the L signal goes into the ST L line and the R signal
goes into ST R line. If you are inputting a mono signal, the
same signal is fed to both ST L and ST R.
3PFL (Pre-Fader Listen) Switch
Use this switch to feed the corresponding RETURN signal,
taken from before the ST and AUX Mix controls, into the PFL
bus, so that you can monitor the signal at the PHONES jack. To
turn the PFL feed on, press the switch in ( ).
3
2
1
3
2
1
MG32-14FX_E.book Page 15 Thursday, June 12, 2003 3:10 PM