Basic use
– using a preset program –
7
ProR3 Digital Reverberator
Basic use
– using a preset program –
Here’s how to select a preset program and use it without adjusting any parameters.
Connections
1. Connect the sound source to the INPUT jacks.
For a stereo sound source, connect the outputs of both channels to the INPUT jacks. For a mon-
aural sound source, use the L input jack.
If the sound source has XLR connectors, make connections using the XLR-3-31 connectors of the
ProR3. If not, use the 1/4" phone jacks.
2. Connect the OUTPUT jacks to the mixer or other external device.
If the mixer has XLR connectors, make connections using the XLR-3-32 connectors of the ProR3.
If not, use the 1/4" phone jacks.
3. Connect the ProR3 to an AC outlet.
Turning the power on (off)
1. Press the POWER switch to turn the power on. (Pressing it again will turn the power off.)
The initial display will appear for a few seconds, and then the program that was being used
when the power was last turned off will be selected.
Warning: Before making connections, make sure that the power is turned off for all
your equipment.
Note:
You may also use a cable which converts between XLR connectors and TRS 1/4" phone jacks.
Note:
When turning on the equipment in a system, always turn on each device in sequence of the sig-
nal flow, starting from signal sources and ending with the power amp. Observing this sequence will
prevent damage to speakers, to other equipment, or to your hearing which can be caused by the noise
that occurs when a device is turned on. Turn on the ProR3 before the other connected equipment.
When turning off the power of the system, turn off devices starting with the power amp and working
backward toward the signal sources.