Quick Guide
PSR-3000/1500 Owner’s Manual 33

Using the Modulation Wheel

The Modulation function applies a vibrato effect to notes played on the keyboard. This is applied to all the keyboard
parts (RIGHT 1, 2 and LEFT). Moving the MODULATION wheel down (towards MIN) decreases the depth of the effect,
while moving it up (towards MAX) increases it.
n•To avoid accidently applying modulation, make sure the MODULATION Wheel is set at MIN before you start playing.
•The MODULATION Wheel can be set to control a different parameter other than vibrato (page 96).
nThe effects caused by using the MODULATION wheel will not be applied to the LEFT part when the Chord Fingering type is set to
the one other than “FULL KEYBOARD” or “AI FULL KEYBOARD” with the [ACMP] and PART ON/OFF [LEFT] turned on.

Using the Metronome

The metronome provides a click sound, giving you an accurate tempo guide when you practice, or letting you hear and
check how a specific tempo sounds.
PITCH BEND
MODULATION
You can set whether the effects caused by the MODULATION Wheel will be applied or not to each of the key-
board part.
1Call up the display.
[FUNCTION] → [D] CONTROLLER → TAB [
®
] → KEYBOARD/PANEL → [A]/[B] 2 MODULATION WHEEL
2Set whether the effects caused by the MODULATION Wheel will be applied or not to each of the keyboard
part by using the [5
π†
]/[6
π†
]/[7
π†
] button.
[5
π†
] button..........Sets whether the effects caused by the MODULATION Wheel will be applied or not to the
LEFT part.
[6
π†
] button..........Sets whether the effects caused by the MODULATION Wheel will be applied or not to the
RIGHT1 part.
[7
π†
] button..........Sets whether the effects caused by the MODULATION Wheel will be applied or not to the
RIGHT2 part.
1Press the METRONOME [ON/OFF] button to start the metronome.
2To stop the metronome, press the METRONOME [ON/OFF] button again.