Yamaha R-V303 IMPEDANCE SELECTOR switch, AC* OUTLETS (SWITCHED), GND* terminal (For turntable use)

Note on connecting only one rear speaker:

You can use only one rear speaker in place of two rear speakers. For connecting one rear speaker, follow the method shown on the right.

SPEAKERS

REAR CENTER REAR

REAR

SINGLE

Rear speaker

IMPEDANCE SELECTOR switch

Be sure to switch the position only when the power to this unit is not on.

Select the position whose requirements your speaker system meets.

(Upper position)

Rear: If you use one rear speaker, the impedance of the speaker must be 6Ω or higher.

If you use two rear speakers, the impedance of each speaker must be 3Ω or higher.

WARNING

Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.

IF THIS UNIT FAILS TO TURN ON WHEN THE STANDBY/ON SWITCH IS PRESSED;

The IMPEDANCE SELECTOR switch may not be set to either end. If so, set the switch to either end when this unit is in the standby mode.

IMPEDANCE SELECTOR

SET BEFORE POWER ON

REAR SINGLE:6ΩMIN. /SPEAKER

DUAL:3ΩMIN. /SPEAKER

	CENTER	6ΩMIN. /SPEAKER
	MAIN	4ΩMIN. /SPEAKER
	REAR SINGLE:8ΩMIN. /SPEAKER
		DUAL:4ΩMIN. /SPEAKER
	CENTER	8ΩMIN. /SPEAKER
	CENTER	8ΩMIN. /SPEAKER
	MAIN	8ΩMIN. /SPEAKER

Center: The impedance of the speaker must be 6Ω or higher.

Main: The impedance of each speaker must be 4Ω or higher.

(Lower position)

Rear: If you use one rear speaker, the impedance of the speaker must be 8Ω or higher.

If you use two rear speakers, the impedance of each speaker must be 4Ω or higher.

Center: The impedance of the speaker must be 8Ω or higher.

Main: The impedance of each speaker must be 8Ω or higher.

(U.S.A. model)

AC* OUTLETS (SWITCHED)

(U.S.A., Europe, Canada, China and General models)

..........................................................	2 SWITCHED OUTLETS
(Australia model)..................................	1 SWITCHED OUTLET

Use these to connect the power cords from your components to this unit.

The power to the SWITCHED outlets is controlled by this unit’s STANDBY/ON switch or the provided remote control transmitter’s POWER/I key. These outlets will supply power to any component whenever this unit is turned on.

The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLETS is 100 watts.

GND* terminal (For turntable use)

Connecting the ground wire of the turntable to the GND terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected.