Yamaha RX-V1000RDS ■Operating the macro, ■Programming a macro, The, English, ADVANCED, OPERATION, 2Press a macro button, 1Set MACRO ON/OFF to ON

■Operating the macro

					MACRO
				MACRO	MACRO ON/OFF
TRANSMIT	RE-NAME CLEAR LEARN		MACRO	OFF ON
SYSTEM
POWER	STANDBY			PHONO
V-AUX	TUNER	MD/TAPE	CD-R	CD	Macro buttons
D-TV/LD	CBL/SAT	VCR 1	VCR 2/DVR	DVD

6CH INPUT

1Set MACRO ON/OFF to ON.2Press a macro button.

Notes

•When you have finished using the Macro feature, set MACRO ON/OFF to OFF.

•While this unit is carrying out a macro program, the unit does not receive any other button’s function until the macro operation has been completed (the TRANSMIT indicator stops flashing).

•Continue to aim the remote control at the component the macro is operating until the macro operation has been completed.

■Programming a macro

You can program your own macros and use the Macro feature to transmit many remote control commands by pressing a single button.

Notes

•The factory-set macro is not cleared when a new macro is programmed for a button. The factory-set macro can be used again when the programmed macro is cleared.

•It is not possible to add a new signal (macro step) to the factory-set macro. Programming a macro changes all macro contents.

•A macro programming is used to transmit learning or setup (or YAMAHA preset) button signals of this remote control to a macro button. If necessary, set up the manufacturer code or program a function with the remote control for your component.

•This remote control handles button signals that operate continuously, such as volume control, as short time interval codes. Macro programming that include these types of macro steps are therefore not recommended.

1Press MACRO by using a ballpoint pen or similar object.“MCR ?” appears in the display window.

MACRO

REMOTE CONTROL FEATURES

2Press a macro button for which you want to program the macro operation.

The button you chose for programming the macro operation and the selected component name appear alternately in the display window.

SYSTEM
POWER	STANDBY			PHONO
V-AUX	TUNER	MD/TAPE	CD-R	CD
D-TV/LD	CBL/SAT	VCR 1	VCR 2/DVR	DVD

Note

•“AGAIN” appears in the display window when a button other than the macro buttons is pressed.

y

•If you want to change the source component, use SOURCE SELECT k/ n or input selector buttons. When you use the input selector buttons, selecting the input is programmed as a macro step, whereas SOURCE SELECT k/ n only changes the component.

3Press the buttons of the functions that you want to include in the macro operation sequence in order.

y

•You can set up to 10 steps (10 functions). After you have set 10 steps, “FULL” appears and the remote control automatically exits from the macro mode.

SYSTEM
POWER	STANDBY			PHONO
V-AUX	TUNER	MD/TAPE	CD-R	CD
D-TV/LD	CBL/SAT	VCR 1	VCR 2/DVR	DVD
		TITLE		6CH	1 MCR 1: DVD input
			ENTER
SOURCE
	DISPLAY	MENU		SOUND
SELECT	SEARCH		– CHAPTER +
POWER	REC	STOP	PAUSE	PLAY	2	MCR 2: DVD a
/

3

MCR 3: DVD p

indicate the number of macro steps you entered

appear alternately so that you can set up the next step

OPERATION ADVANCED

Note

•If you do not press any button within 30 seconds during steps 2 and 3, the macro programming process is canceled. If this happens, start over from step 1.

Note

•“NG” appears in the display window when programming has not been done correctly. In this case, start over from step 2.

English

61