Yamaha RX-V1000RDS TROUBLESHOOTING, ■ General, page, Cause, Remedy, Problem, APPENDIX, Refer to

APPENDIX

TROUBLESHOOTING

Refer to the chart below when the unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, set this unit in the standby mode, disconnect the power cord, and contact the nearest authorized YAMAHA dealer or service center.

■ General

Problem	Cause	Remedy	Refer to
			page
The unit fails to turn on	The power cord is not connected or the plug	Firmly connect the power cord.	19
when STANDBY/ON (or	is not completely inserted.
SYSTEM POWER) is
	The IMPEDANCE SELECTOR switch	Set the switch fully to the left or right	19
pressed, or enters in the
	on the rear panel is not fully set to the	position when the unit is in the standby
standby mode soon
	left or right position.	mode.
after the power has
	The protection circuitry has been	Make sure all speaker wire connections on	16, 17
been turned on.
	activated.	this unit and on all speakers are secure and
		that the wire for each connection does not
		touch anything other than its respective
		connection.
No sound and/or no	Incorrect input or output cable connections.	Connect the cables properly. If the problem	12 – 15
picture.		persists, the cables may be defective.
	An appropriate input source has not	Select an appropriate input source with	24
	been selected.	INPUT l / hor 6CH INPUT (or the input
		selector buttons).
	The speaker connections are not secure.	Secure the connections.	16, 17
	The main speakers to be used have not	Select the main speakers with SPEAKERS A	24
	been selected properly.	and/or B.
	The volume is turned down.	Turn up the volume.	25
	The sound is muted.	Press MUTE or any operation buttons of this	25
		unit to cancel a mute and adjust the volume.
	Digital signals other than PCM audio,	Play a source whose signals this unit can	—
	Dolby Digital or DTS signal which this	reproduce.
	unit cannot reproduce are being input to
	this unit by playing a CD-ROM, etc.
No picture.	There is no S-video connection between this	Connect the monitor’s S-video input jack to	14, 15
	unit and the video monitor, although	this unit’s S VIDEO MONITOR OUT jack.
	S-video signals are being input to this unit.
The sound suddenly	The protection circuit has been activated	Check the IMPEDANCE SELECTOR	19
goes off.	because of a short circuit, etc.	switch is set to the appropriate position and
		then turn the unit back on.
		Check the speaker wires are not touching	16, 17
		each other and then turn the unit back on.
	The sleep timer has functioned.	Turn on the power, and play the source	49
		again.
	The sound is muted.	Press MUTE or any operation buttons of this	25
		unit to cancel a mute and adjust the volume.		APPENDIX
Only the speaker on one	Incorrect cable connections.	Connect the cables properly. If the problem	12 – 17
side can be heard.		persists, the cables may be defective.
	Incorrect setting of “3 L/R BALANCE”	Adjust it to the appropriate position.	44
	on the SET MENU.
				English

75