CONNECTIONS

Connecting to an External

Amplifier

If you want to increase the power output to the speakers, or want to use another amplifier, connect an external amplifier to the OUTPUT jacks as follows.

Notes

•When RCA pin plugs are connected to the OUTPUT jacks for output to an external amplifier, it is not necessary to use the corresponding SPEAKERS terminals.

•No signals will be output from any other OUTPUT jacks than MAIN jacks when SPEAKER A is turned off with ZONE B selected for “1G SP B SET” on the SET MENU.

OUTPUT

 

SUB

MAIN

 

 

WOOFER

 

 

3

 

L

1

 

 

R

 

 

CENTER

REAR

 

 

 

(SURROUND)

 

4

 

L

2

5

 

R

 

REAR

 

 

 

CENTER

 

 

1MAIN jacks

Main channel line output jacks.

Note

•The signals output through these jacks are affected by the BASS, TREBLE and BASS EXTENSION settings.

2REAR (SURROUND) jacks

Rear channel line output jacks.

3SUBWOOFER jack

When using a subwoofer with built-in amplifier, including the YAMAHA Active Servo Processing Subwoofer System, connect the input jack of the subwoofer system to this jack. Low bass signals distributed from the main, center and/or rear channels are directed to this jack if they are assigned to this jack. (The cut-off frequency of this jack is 90 Hz.) The LFE (low-frequency effect) signals generated when Dolby Digital or DTS is decoded are also directed if they are assigned to this jack.

Notes

•Adjust the volume level of the subwoofer with the control on the subwoofer. It is also possible to adjust the volume level by using the remote control of this unit (see ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS on page 66).

•Depending on the settings of “1 SPEAKER SET” and “10 LFE LEVEL” on the SET MENU, some signals may not be output from the SUBWOOFER jack.

4CENTER jack

Center channel line output jack.

5REAR CENTER jack

Rear center channel line output jack.

Connecting to the 6CH INPUT

Jacks

This unit is equipped with 6 additional input jacks (left and right MAIN, CENTER, left and right SURROUND and SUBWOOFER) for discrete multi-channel input from an external decoder, sound processor or pre-amplifier.

Connect the output jacks on your external decoder to the 6CH INPUT jacks. Be sure to match the left and right outputs to the left and right input jacks for the main and surround channels.

Notes

•When 6CH INPUT is selected, the signals input to the 6CH INPUT jacks have priority over any other input source.

•When you select 6CH INPUT as the input source, this unit automatically turns off the digital sound field processor, and you cannot listen to DSP programs.

•When you select 6CH INPUT as the input source, settings of “1 SPEAKER SET (1A to 1E)” on the SET MENU do not apply.

•When headphones are used, only main L/R channels are output.

•Setting for “15 6CH INPUT SET” on the SET MENU will be applied when 6CH INPUT is selected.

20