Clearing Learned Functions,

Renamed Source Names, and

Setup Manufacturer Codes

You can clear learned functions, renamed source names and set up manufacture codes. You can also revert the remote control to the factory setting.

1 Press CLEAR by using a ballpoint pen or similar object.

CLEAR

Note

•If you do not press any button within 30 seconds during steps 2 and 3, the clearing process is canceled. If this happen, start over from step 1.

2 Press u/ dto select the clear mode.

The mode is shown in the display window in the following order:

+

TV VOL

CH

TV MUTE

CH

–

+

SELECT

PRESET

 

PRESET

 

TV VOL

 

 

–

 

(L: name of a component) Clears all learned functions for the component area.

Clears all learned functions for this unit control area.

Clears all learned functions.

Clears all renamed source names in the display window.

Clears all programmed functions including setup manufacturer codes. This returns to the factory settings.

REMOTE CONTROL FEATURES

3 Press and hold CLEAR again for about 3 seconds.

“C:OK” appears in the display window.

CLEAR

Note

•“C:NG” appears in the display window if the operation is unsuccessful. In this case, start over from step 2.

4 Press CLEAR to exit from the clearing mode.

CLEAR

Note

•“ERROR” appears in the display window when pressing buttons other than indicated in each step, or more than one button at once.

OPERATION

ADVANCED

 

 

English

49