Yamaha RX-V1400 Starting the setup, English, PREPARATION, DISTANCE, SIZE, EQUALIZING or LEVEL, press SET MENU to enter the SET MENU, 2Press AMP to select the AMP mode, then

Starting the setup

For best results, make sure the room is as quiet as possible during the auto setup procedure. If there is too much ambient noise, the results may not be satisfactory.

y

If your subwoofer can adjust the output volume and the crossover frequency, set the volume to about half way (or slightly less) and set the crossover frequency to the maximum.

1Switch on the receiver and video monitor.

Make sure the OSD is displayed.

2Press AMP to select the AMP mode, thenpress SET MENU to enter the SET MENU.

AMP	SET MENU
then	MENU
	A/B/C/D/E

3 Press u / d to select AUTO SETUP, then press i once to enter the main menu.

+

TV VOL

CH	TV MUTE	CH
–		+
	SELECT
PRESET		PRESET
	TV VOL
	–

SET MENU

. ;AUTO SETUP ;MANUAL SETUP

p/p :	Up/Down
SELECT :	Select

+

TV VOL

CH	TV MUTE	CH
–		+
	SELECT
PRESET		PRESET
	TV VOL
	–

4Press u / d repeatedly to select WIRING,DISTANCE, SIZE, EQUALIZING or LEVEL.

1 AUTO SETUP

.
WIRING;;;;;CHECK

DISTANCE;;;CHECK

SIZE;;;;;;;CHECK

SWFR;;;;;;;SKIP SETUP......AUTO

START PUSH SELECT

p/p	:	Up/Down
-/+	:	Change

AUTO SETUP

5When WIRING, DISTANCE, SIZE or LEVEL is selected, press j / i to select:

CHECK To automatically check and adjust the selected item.

SKIP To skip the selected item and perform no adjustments.

y

When using THX speakers, set SIZE to SKIP and make sure that SMALL or SMLx2 is selected in SPEAKER SET (page 49) and that 80Hz is selected in CROSS OVER (page 50).

When EQUALIZING is selected, press j / i to select:

FRONT To adjust the frequency response of each speaker in accordance with the sound of your front speakers.

Recommended if your front speakers are of much higher quality than your other speakers.

FLAT	To average the frequency response of
	all speakers. Recommended if all of
	your speakers are of similar quality.
LOW	To average the frequency response of
	all speakers, giving priority to the
	accuracy of bass frequencies.
MID	To average the frequency response of
	all speakers, giving priority to the
	accuracy of mid-range frequencies.
HIGH	To average the frequency response of
	all speakers, giving priority to the
	accuracy of high frequencies.
SKIP	To skip the selected item and perform
	no adjustments.

6Press d to select SETUP, then press j / i to select:

AUTO	To automatically perform the entire
	auto setup procedure.
STEP	To pause for confirmation between
	each check in the auto setup procedure.
RELOAD	To restore the last auto setup setting.

7Press d to select START PUSH +, then press i.

Loud test tones will be output from each speaker and WAIT appears during the auto setup procedure.

Note

If E-10:OTHER ERROR appears during testing, restart the procedure from step 3.

PREPARATION

English

25