Yamaha RX-V1400 Changing source names in the display window, 2Press RE-NAMEusing a, ballpoint pen or similar object, 3Press u / d to select and enter a character

REMOTE CONTROL FEATURES

5Press and hold the button you want to program on the other remote control until “OK” appears in the display window.

TV	POWER		DTV	AUX	PHONO	SYSTEM POWER	TRANSMIT
				V
				-
			1 VCR	CBL/SAT	TUNER	STANDBY	CLEAR NAME–RE
AV	POWER		DVR/VCR2	MD/TAPE	CD	SLEEP
	AMP	SELECT	DVD	R-CD	IN CH MULTI	MODE INPUT	LEARN

Notes

• “NG” appears in the display window if programming was

unsuccessful. In this case, start over from step 5.

• This remote control can learn approximately 120 functions.

However depending on the signals learned, “FULL” may

appear in the display before you program 120 functions. In this

Changing source names in the display window

You can change the name that appears in the display window on the remote control if you want to use the different name than the factory preset. This is useful when you have set the input selector to control a different component.

1Press an input selector button to select the source component you want to rename.

The selected component name appears in the display window.

PHONO	TUNER	CD	MULTI CH IN
V-AUX	CBL/SAT	MD/TAPE	CD-R
DTV	VCR 1	DVR/VCR2	DVD

2Press RE-NAME using a

case, clear unnecessary programmed functions to make room

for further learning.

ballpoint pen or similar object.

RE-NAME

6Repeat steps 4 and 5 to program additional functions.7Press LEARN again to exit from the learning mode.

LEARN

Notes

•Learning may not be possible in the following cases:

–When the batteries in the remote control for this unit or other components are weak.

–When the distance between the two remote controls is too great or too small.

–When the remote control infrared windows are not facing at the appropriate angle.

–When the remote control is exposed to direct sunlight.

–When the function to be programmed is continuous or uncommon.

•“ERROR” appears in the display window if you press more than

one button at the same time.

3Press u / d to select and enter a character.

Pressing d changes the character as follows:

A to Z, a to z, 0 to 9, space, -(hyphen), and /(slash). (Pressing u changes the characters in reverse order.)

+

TV VOL

CH	TV MUTE	CH
–		+
	SELECT
PRESET		PRESET
	TV VOL
	–

4Press j / i to move the cursor to the next position.

+

TV VOL

CH	TV MUTE	CH
–		+
	SELECT
		PRESET
	TV VOL
	–

y

If you want to continue setting up names for other components, press TV MUTE/SELECT and repeat steps 1, 3 and 4.

5Press RE-NAME again to exit from the renaming mode.

RE-NAME

62