Yamaha RX-V2200 Clearing a Learned Function or, Macro, ■To clear a learned function, ■To clear the macro function, from the learning mode, 4 Press LEARN again to exit

REMOTE CONTROL FEATURES

3 Press k / n to select the clear mode.

The mode is shown in the display window in the following order:

(L: name of a component) Clears all learned functions for the component area. Press the input selector button, Å or ı to select the component.

Clears all learned functions for this unit control area.

Clears all learned functions.

Clears all programmed macros.

Clears all renamed source names in the display window.

Clears all programmed functions including setup manufacturer codes. This returns to the factory settings.

You can clear the function learned in a certain programmable button in each area.

■To clear a learned function

1 Press an input selector button, Å or ı to select the source component you want to clear the function.

The selected component name appears in the display window.

2 Press LEARN by using a ballpoint pen or similar object.

“LEARN” and the selected component name appear alternately in the display window.

LEARN

4 Press and hold CLEAR again for about 3 seconds.

“C:OK” appears in the display window.

CLEAR

Note

•“C:NG” appears in the display window if the operation is unsuccessful. In this case, start over from step 2.

5 Press CLEAR to exit from the clearing mode.

Once you have cleared a learned function or macro for a button, the button reverts to the factory setting.

CLEAR

Note

•“ERROR” appears in the display window under the following circumstances:

–when pressing a button other than the cursor and ENTER;

–when pressing more than one button at once; or

–when MACRO ON/OFF, 10KEY/DSP or PARAMETER/SET MENU is switched to another position.

Note

•If you do not press any button within 30 seconds during step 3, the clearing process is canceled. If this happens, start over from step 2.

3 Press the button that you want to clear for 3seconds as pressing CLEAR by using a ballpoint pen or similar object.

“C:OK” appears in the display window.

CLEAR

4 Press LEARN again to exit	LEARN
from the learning mode.

■To clear the macro function

1 Press an input selector button, Å or ı to select the source component for which you want to clear the function.

The selected component name appears in the display window.