Yamaha RX-V2200 ■Remote control, Cause, Remedy, Problem, Refer to page

TROUBLESHOOTING

■Remote control

Problem	Cause	Remedy
The remote control	Wrong distance or angle.	The remote control will function within a
does not work nor		maximum range of 6 m (20 feet) and no more
function properly.		than 30 degrees off-axis from the front panel.
	Direct sunlight or lighting (from an	Reposition this unit.
	inverter type of fluorescent lamp, etc.) is
	striking the remote control sensor of this
	unit.
	The batteries are weak.	Replace all batteries with new ones and press
		RESET.
	The internal microcomputer has	Remove the batteries from the battery
	“frozen”.	compartment once and then put them back.
The remote control	The batteries of this remote control and/	Replace the batteries.
does not “learn” new	or the other remote control are too weak.
functions.
	The distance between the two remote	Place the remote controls at the proper distance.
	controls is too much or too little.
	The signal coding or modulation of the	Learning is not possible.
	other remote control is not compatible
	with this remote control.
	Memory capacity is full.	Further learning is not possible without deleting
		unnecessary functions.
	The internal microcomputer has	Remove the batteries from the battery
	“frozen”.	compartment once and then put them back.
Continuous functions	The learning process is incomplete.	Be sure to press and hold the function button on
such as volume		the other remote control until “OK” appears in
adjustment are learned,		the display window.
but operate only for a
moment before
stopping.

Refer to page

7

—

3

3

3

44

44

47, 48

3

44

After this unit has been exposed to a strong external electric shock (such as lightning and strong static electricity) or if you mishandle the operation of this unit, it may not function properly. In these cases, set this unit in the standby mode, disconnect the power cord, plug it back in after 30 seconds, and start operating.

80