AUTOMATIC PRESET TUNING

You can also make use of an automatic preset tuning function for FM stations only. With this function, this unit performs automatic tuning and stores stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the manual preset tuning method on page 27.

L R

2 1 3

To store stations

1 FM/AM

2

MEMORY

PRESET

MAN'L/

MEMORY AUTO

Press and hold for

Flashes.

more than 3 seconds.

 

3

DOWN TUNING UP

To tune to higher frequencies, press right side once. To tune to lower frequencies, press left side once.

*If the TUNING button is not pressed for a while, automatic preset tuning begins automatically toward higher frequencies.

Automatic preset tuning begins from the frequency currently displayed. Received stations are programmed to A1, A2 ...

A8 sequentially.

*If more than 8 stations are received, they are programmed to the preset station numbers in other groups in alphabetical order.

If you want to store the first station received by the automatic preset tuning to a desired preset station number.

If, for example, you want to store the first received station to C5, select “C5” by using the A/B/C/D/E button and the preset station number selector buttons after pressing the MEMORY button in step 2. Then press the TUNING button. The first received station is stored to C5, followed by C6, C7, etc. in sequence.

If stations are stored up to E8, the automatic preset tuning is automatically concluded.

When the automatic preset tuning concludes

The display shows the frequency of the last preset station. Check the contents and the number of preset stations by following the procedure of the section “To recall a preset station” on page 27.

To recall a preset station

Follow the procedure in the section “To recall a preset station” on page 27.

* A recalled station is shown by the frequency in the display.

Notes

You can replace a preset station with another FM or AM station manually by following the procedure in the section “To store stations” on page 27.

If the number of received stations is not enough to be stored up to E8, the search is finished automatically after searching all frequencies.

With this function, only stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune to it in monaural manually and program it by following the procedure in the section “To store stations” on page 27.

28