SETUP CODES

Presetting the remote control transmitter

Perform the presetting procedure for each component you want to control with the remote control transmitter.

Note

If your component does not respond to any of the codes listed for the manufacturer, use the original remote control transmitter that was supplied with the component.

English

To control your components (MD recorder, DVD player, TV, etc.)

1.Turn on the component to be used.

2.Press the component selector button that matches the component to be controlled (TAPE/MD, DVD/LD, TV etc.).

3.Press both VOLUME buttons ( ) at the same time for about four seconds so that the indicator flashes twice.

4.Use the numeric buttons to enter the four-digit manufacturer’s code for the component to be used. Make sure that the indicator flashes twice.

If the indicator does not flash, repeat step 3 and re-enter the code.

6CH

2CH

To use a second (and third)VCR

You can control a second (and/or third) VCR in the CBL/DBS and DVD MENU modes if a CBL (or DBS) or DVD player is not being used.

If you want to control a second (and/or third) VCR in the DVD MENU mode, you must preset the code for an LD player in that mode.

1.Turn on the VCR to be used.

2.Press the component selector button CBL/DBS or DVD MENU.

3.Press both VOLUME buttons ( ) at the same time for about four seconds so that the indicator flashes twice.

4.Use the numeric buttons to enter the four-digit code for the second (or third) VCR. Make sure that the indicator flashes twice. If the indicator does not flash, repeat step 3 and re-enter the code.

Returning to the factory-set codes

To return all components to the factory-set codes, follow these steps.

1.Press a component selector button other than AMP<TUNER>.

2.Press both VOLUME buttons ( ) for about four seconds at the same time so that the indicator flashes twice.

3.Enter the code number “9990”.

4.Make sure that the indicator flashes twice.

To return each component to the factory- set codes, follow these steps.

1.Press the component selector that matches the component to be returned to the factory-set codes.

2.Press both VOLUME buttons ( ) at the same time for about four seconds so that the indicator flashes twice.

3.Enter the code number “0000”.

4.Make sure that the indicator flashes twice.

The following codes are preset by the factory.

Factory-set codes

Component

Component

Code

selector

 

 

 

 

 

TV

TV

0101

 

 

 

CBL/DBS

DBS tuner

0006

 

 

 

VCR

VCR

0002

 

 

 

DVD/LD

DVD player

0008 YAMAHA

 

 

 

CD

CD player

0005 YAMAHA

5.Press POWER (or any other button) on the remote control transmitter to check if you have preset the code correctly. If the component cannot be controlled by the remote control transmitter, try entering another code for the same manufacturer.

6CH

2CH

5.Press POWER (or any other button) on the remote control transmitter to check if you have preset the code correctly. If the VCR cannot be controlled by the remote control transmitter, try entering another code for the same manufacturer.

TAPE/MD

Tape deck

0004 YAMAHA

We recommend that you write all code numbers you have preset on the “Quick Reference Card”.

41