Yamaha RX-V595A Notes About The Remote Control, Battery installation, Battery replacement

NOTES ABOUT THE REMOTE CONTROL

Battery installation

1.Turn the remote control over and slide the battery compart- ment cover in the direction of the arrow.

2.Insert the batteries (AA, R6 or UM-3 type) according the polarity markings on the inside of the battery compartment.

3.Close the battery compartment cover.

2

1

3

Battery replacement

If the remote control operates only when it is close to the unit, the batteries are weak. Replace all the batteries with new ones.

Be sure to replace the batteries within about two minutes. If it takes longer than two minutes, the codes preset for the remote control will return to the factory settings.

Notes

•Use only AA, R6 or UM-3 batteries for replacement.

•Be sure the battery polarity is correct. (See the illustration inside the battery compartment.)

•Remove the batteries if the remote control will not be used for an extended period of time.

•If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

Remote control operation range

Remote control sensor

Within approximately

6 m (20 feet)

Notes

•There should be no large obstacles between the remote control and the unit.

•If the remote control sensor is directly illuminated by strong lighting (especially from an inverter type of fluorescent lamp), it might cause the remote control not to work correctly. In this case, reposition the unit to avoid direct lighting.

48