Yamaha RX-V595A owner manual When playing back a source encoded with DTS

	SYMPTOM	CAUSE	REMEDY
	The remote control does not work.	Direct sunlight or lighting (from an	Change the position of this unit.
		inverter type of fluorescent lamp, etc.) is
control		striking the remote control sensor of this
		unit.
		The manufacturer’s code has not been	Set the code again.
Remote		set properly.
		The proper manufacturer’s code for the	Try entering another code for the same
		component to be controlled has not	manufacturer.
		been set.
		The component to be controlled has not	Set the SELECTOR DIAL to the proper
		been selected.	position.
	The sound is degraded when	This unit is in the standby mode.	Turn on the power of the unit.
	listening with the headphones to a
Others	CD player or tape deck that is
	connected to this unit.
	There is noise interference from	The unit is too close to the digital or	Move the unit further away from such
	digital or high-frequency equipment	high-frequency equipment.	equipment.
	or the unit.

When playing back a source encoded with DTS

SYMPTOM	CAUSE	REMEDY
A loud hissing noise is heard when you	The player which plays back the source	The player must be connected to a
play back a source encoded with DTS.	is not connected to a digital audio signal	digital audio signal input terminal of this
	input terminal of this unit.	unit besides the analog audio signal
		terminal connections.
	The ANALOG input mode is selected on	Select a proper input mode on this unit
	this unit.	to turn on the DTS decoder built into
		the unit.
A percussive noise is heard when you	If the AUTO input mode is selected,	Set the input mode of the currently
begin playing back a source encoded	depending on some sources, there may	selected input source to DTS.
with DTS.	be a case that a noise is heard while
	this unit is identifying the format of the
	input signal.
No sound is heard when you play back a	The DTS decoder built into this unit	Set the player’s digital volume control
source encoded with DTS, even though	does not function because the player	at the maximum, neutral or ineffective
the AUTO input mode is selected on this	has a digital volume control and it is set	position.
unit.	at a position other than “maximum,”
	“neutral” or “ineffective.”
No sound is heard when you play back	A source encoded with DTS cannot be
an MD or DAT on to which you have	recorded on to an MD or DAT.
recorded a source encoded with DTS.
No sound is heard when you play back a	In the AUTO mode, the DTS-decoding	Press INPUT MODE on the front panel
source (CD, etc.) even though the	mode cannot be automatically changed	or INPUT (for the currently selected
currently selected input mode is AUTO.	to the normal (PCM) digital signal input	source) on the remote control so that
	mode.	AUTO appears on the display.

Notes

•It is necessary to use a DTS decoder to play back a source encoded with DTS, so the player which plays back the source must be connected to a digital audio input terminal of this unit in the way described in this manual. If this connection is not made or only a D-to-A converter is being used without using a DTS decoder, when you play back the source, only a loud hissing noise will be heard.

•If you make a search (or skip, etc.) operation while playing back a source encoded with DTS, the “dts” indicator goes out from the display. This is because this unit automatically changes the DTS-decoding mode to the standard (PCM) digital signal input mode to prevent a noise from being output.

52