Manuals / Yamaha / Home Audio / Stereo System

Yamaha RX-V595A owner manual Antenna Connections, Connecting the AM loop antenna

Models: RX-V595A

1 63

Download 63 pages 31.57 Kb

Page 20

ANTENNA CONNECTIONS

ANTENNA CONNECTIONS

Each antenna should be correctly connected to the designated terminals, referring to the following diagram.

Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may result in improvement.

Outdoor * You may be unable to obtain good FM radio

FM antenna reception depending on your local conditions (distance from the broadcast

station, interposing buildings and

mountains, etc.). Consult your dealer or authorized service center and be sure to install an antenna that suits your local conditions.

Install the special FM outdoor antenna in a high place as far away from any roads as possible to avoid being affected by automobile ignition noise.

75-ohm/300-ohm antenna adapter

75-ohm coaxial cable

Indoor FM antenna (included)

*Firmly insert the connector into the FM ANT terminal.

(U.S.A. model)

Outdoor AM antenna

*If you cannot obtain good reception with the AM loop antenna, connect 5 m to 10 m of vinyl covered wire to the AM ANT terminal and extend it outdoors from a window. (Be sure to also connect the AM loop antenna at this time.)

AM loop antenna (included)

75-ohm/300-ohm

antenna adapter

Ground 300-ohm feeder

GND terminal

For maximum safety and minimum interference, connect the GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.

Connecting the AM loop antenna

1 1	Press the tab and unlock the terminal hole.	2 Attach the loop antenna to the
2	Connect the AM loop antenna lead wires to the	antenna stand.
	AM ANT and GND terminals.
3	Return the tab to its original position to lock the	Loop antenna
	lead wires. Lightly pull the lead wires to confirm
	a good connection.

3 Orient the AM loop antenna so that the best reception is obtained.

1

3

Antenna stand

2

•The AM loop antenna should be placed away from this unit. The antenna may be hung on a wall.

•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.

20

Image 20

Yamaha RX-V595A owner manual Antenna Connections, Connecting the AM loop antenna

Contents

U C A RX-V595aNatural Sound AV Receiver Ampli-Tuner audio-vidéo SAFETY INSTRUCTIONS FCC INFORMATION for US customers only We Want You Listening For A LifetimeEnglish SUPPLIED ACCESSORIES ACCESSOIRES FOURNIS FEATURES CONTENTS5-Channel Power Amplification Test Tone Generator for Easier Speaker Balance AdjustmentCAUTION READ THIS BEFORE OPERATING YOUR UNIT FREQUENCY STEP switch China model onlyChina model only 15. Voltage Selector China model onlyFEATURES OF THE SOUND EFFECTS IntroductionDigital Sound Field Processing Dolby Pro LogicDolby Digital DTS Digital SurroundCINEMA DSP Dolby Surround + DSP / DTS + DSP Dolby Pro Logic + 2 Digital Sound FieldsDolby Digital or DTS + 3 Digital Sound Fields EnglishCONTROLS AND THEIR FUNCTIONS FRONT PANELEnglish q INPUT MODEDISPLAY PANEL 2 MEMORY indicator3 AUTO TUNING indicator 4 TAPE/MD MON indicatorSPEAKER SETUP SPEAKER PLACEMENTSPEAKERS TO BE USED EnglishAC OUTLETS SWITCHED CONNECTIONSCONNECTIONS WITH OTHER COMPONENTS GND terminal for turntable useCONNECTING TO DIGITAL COAXIAL AND/OR OPTICAL TERMINALS EnglishCONNECTING TO S VIDEO TERMINALS CONNECTING TO VIDEO AUX TERMINALS ON THE FRONT PANELCONNECTING TO AN EXTERNAL DECODER IMPEDANCE SELECTOR SWITCHEnglish IMPEDANCE SELECTORCONNECTING SPEAKERS Main speaker connectionsSubwoofer connection Rear speaker connectionsHow to connect Connecting to the MAIN SPEAKERS terminalsConnecting to the REAR and CENTER SPEAKERS terminals EnglishConnecting the AM loop antenna ANTENNA CONNECTIONSADJUSTMENTS BEFORE USING THIS UNIT SELECTING THE OUTPUT MODES1. CNTR CENTER SPEAKER 2. REAR REAR SPEAKERS 3. MAIN MAIN SPEAKERSADJUSTMENT METHOD English SPEAKER BALANCE ADJUSTMENT4 4,7 4 Set BASS, TREBLE and BALANCE to the “0” position Adjust the level Pressing raises and lowers the level EnglishBASIC OPERATION TO PLAY A SOURCEWhen you have finished using this unit EnglishNotes on using INPUT Switching the input mode for DVD/LD and TV/DBSAUTO ANALOGTO RECORD A SOURCE ON TAPE, MD OR VIDEO CASSETTE EnglishMANUAL TUNING TUNINGAUTOMATIC TUNING English MANUAL PRESET TUNINGTo store stations To recall a preset station Memory back-upAUTOMATIC PRESET TUNING for FM stations only When automatic preset tuning is completedEnglish To store stationsEXCHANGING PRESET STATIONS SETTING THE SLEEP TIMER To cancel the selected SLEEP time120 90 60 To set the SLEEP timeSOUND FIELD PROGRAM For movie or audio/video sources3 presence & surround L, R For Hi-Fi Audio sourcesEnglish 1 2 3 4 TO CANCEL THE SOUND EFFECTPLAYING A SOURCE WITH THE DIGITAL SOUND FIELD PROCESSOR DSP EFFECT English ADJUSTING THE DELAY TIME AND SPEAKER OUTPUT LEVELSAdjustment method Adjusting the delay time ADJUSTMENTS IN THE “SET MENU” MODE C.DELAY CENTER DELAYD.D.LFE Adjusting the level of the LFE channel for Dolby Digital D.RNG Adjusting the dynamic rangeC.DELAY Adjusting the delay of center sounds dialog, etc GUARD Memory guardINPUT Selecting the mode of the TV/DBS input Adjustment methodREMOTE CONTROL Components which can be controlledBasic operation EnglishAMP/TUN English TAPE/MDTAPE DVD/LD DVD MENUEnglish CBL/DBSNote You can only control your VCR if you have preset the code for it NOTES ABOUT THE REMOTE CONTROL Battery installationBattery replacement Remote control operation rangeSETUP CODES Presetting the remote controlTo control your components MD recorder, DVD player, TV, etc To use a second and third VCRTROUBLESHOOTING English suitable for the monaural sound sourceOthers When playing back a source encoded with DTSRemote SPECIFICATIONS AUDIO SECTIONVIDEO SECTION EnglishFM SECTION GENERALAM SECTION China and General modelsPage CABLE DBS TUNERDVD PLAYER LD PLAYERCD PLAYER MD RECORDERLIST OF MANUFACTURERS’ CODES U.S.A, Canada and China models CABLE DBS TUNERDVD PLAYER LD PLAYERCD PLAYER MD RECORDERV403280 Quick Reference Card AMP/TUNTAPE/MD DVD/LDCBL/DBS Quick Reference CardDVD MENU