TUNING

Quick automatic-search tuning (AUTOMATIC TUNING) is effective when station signals are strong and there is no interference. However, if the signal from the station you want to select is weak, you must tune in to it manually (MANUAL TUNING).

2 3

1

AUTOMATIC TUNING

MANUAL TUNING

Set the SELECTOR DIAL to the AMP/TUN position on the remote control and select TUNER as the input source.

1 Select the reception band (FM or AM) and confirm it on the display.

Front panel

or

2 Press TUNING MODE so that the “AUTO TUNING” indicator lights up on the display.

Front panel

Lights up

3 To tune in to a higher frequency, press the UP side of TUNING once.

To tune in to a lower frequency, press the DOWN side of TUNING once.

Front panel

*If the station where the tuning search stops is not the desired one, press once more.

*If the tuning search does not stop at the desired station (because the signal from the station is weak), take the manual tuning procedure.

1 Select the reception band (FM or AM) and confirm it on the display.

Front panel

or

2 Press TUNING MODE.

Front panel

Check that the “AUTO

TUNING” indicator goes off.

3 Tune in manually to the desired station.

Front panel

* To continue the tuning search, press and hold the button.

Notes

•If you tune in manually to an FM station, it will be automati- cally received in monaural mode to increase the signal quality.

•When tuned in to a station, the frequency of the received station is shown on the display. If an RDS station that employs the PS data service is being received, the station name is also shown on the display.

28