PLAYING A SOURCE WITH THE DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT

2

2

1 Follow steps 1 to 7 shown in “BASIC OPERATIONS” on pages 25 to 26.

2 Select the desired DSP program that is suitable for the source.

Front panel

Remote control

 

or

Press DSP. While the indicator lights up for about three seconds, select a DSP program using the numeric buttons (1 to 8).

*If the SELECTOR DIAL is set to the DSP position, you can also select a DSP program using the numeric buttons (1 to 8).

3 If desired, adjust the delay time and the output level of each speaker. (For details, see pages 44 and 45.)

Notes

•You can select the program for each of the input sources. Once you select a program, it is linked with the input source selected at that time. So, when you select the input source next time, the same program is automatically called.

•If you prefer to cancel the DSP, press EFFECT or EFCT ON/ OFF. The sound will be the normal 2-channel stereo without surround sound effect.

•When a monaural sound source is played with DOLBY PRO LOGIC or DOLBY PRO LOGIC ENHANCED, no sound is heard from the main speakers and the rear speakers. Sound is heard only from the center speaker. However, if the NONE position is selected on “1. CNTR” in the SET MENU mode, the main speakers output the sound of the center channel.

•If the main-source sound is considerably altered by overadjustment of BASS or TREBLE when this unit’s Dolby Pro Logic Surround decoder or Dolby Digital decoder is used, the relationship between the center and rear channels may produce an unnatural effect.

The name of selected program appears on the display.

42