BASIC OPERATION

To select the tape deck connected to this unit’s TAPE/MD terminals or the source connected to this unit’s EXTERNAL DECODER INPUT terminals as the input source.

Use one of the buttons figured below to make the corresponding indicator illuminated on the display.

Front panel

TAPE/MD /EXT. DECODER

Press once or more.

TAPE/MD

MONITOR

or

Remote control

HALL

 

MOVIE

 

THEATER 2

EXT. DEC.

or

TAPE/MD

0

3

Notes on input source selection

●Note that selecting an input source means that the source which is connected to the corresponding input terminals on the rear panel is selected.

*To select the source connected to the VIDEO AUX terminals on the front panel, select “V-AUX”.

●If you select a video input source without canceling the source already selected in the way described on the left, you will see the picture of the video input source and hear the sound of the source already selected.

●If a different audio source is selected with the input selector keys on the remote controller while enjoying a video source, the sound from the newly selected audio source is heard, but the picture from the video source can still be seen.

●When you select an input source, the DSP program (or the state of no DSP program is used) which was used when the same input source was last selected will be automatically recalled.

●If a nonstandardized source is played back, or the unit playing back a source is not operating correctly, “INPUT DATA ERR” appears on the display.

English

TAPE/MD

MONITOR

“TAPE MONITOR”: Lights up for a few seconds just after you select the tape deck connected to the TAPE/MD terminals.

“EXT. DECODER”: Lights up when the source connected to the EXTERNAL DECODER INPUT terminals is selected.

Note

The input source selected in this way has priority over any other input source already selected. To select another input source, cancel both of the sources connected to the TAPE/MD and EXTERNAL DECODER INPUT terminals.

To cancel both of the sources connected to the TAPE/MD and EXTERNAL DECODER INPUT terminals.

Use one of the buttons figured above to make neither “EXT. DECODER” nor “TAPE/MD MONITOR” are illuminated on the display.

35