CAUTION : Read this before operating your unit.
1.To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.
2.Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the unit to rain or water.
3.Never remove the unit cover. Contact your dealer if an object falls inside the unit.
4.Do not use force on switches, controls or connection wires. When moving the unit, first disconnect the power plug and the wires connected to other equipment. Never pull on the wires themselves.
5.The openings on the unit cover assure proper ventilation of the unit. If these openings are obstructed, the temperature inside the unit will rise rapidly. Therefore, avoid placing objects against these openings, and install the unit in a
<Singapore model only>
Be sure to allow a space of at least 20 cm behind, 20 cm on the both sides and 30 cm above the top panel of the unit to prevent fire and damage.
6.The voltage used must be the same as that specified on this unit. Using this unit with a higher voltage than specified is dangerous and may result in fire or other accidents. YAMAHA will not be held responsible for any damage resulting from use of this unit with a voltage other than specified.
7.Digital signals generated by this unit may interfere with other equipment such as tuners, receivers or TVs. Move this unit farther away from such equipment if interference is observed.
8.Always set the VOLUME control to
9.Do not attempt to clean the unit with chemical solvents; this might damage the finish. Use a clean, dry cloth.
10.Be sure to read the “TROUBLESHOOTING” section regarding common operating errors before concluding that the unit is faulty.
11.When not planning to use this unit for long periods of time, disconnect the AC power plug from the wall outlet.
12.To prevent lightning damage, disconnect the AC power plug and antenna cable when there is an electrical storm.
13.Grounding or polarization – Precautions should be taken so that the grounding or polarization of an appliance is not defeated.
14.Do not connect an audio unit to the AC outlet on the rear panel if the equipment requires more power than the outlet is rated to provide.
15.Voltage Selector (China and General Models only)
The voltage selector on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC main supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
This unit is not disconnected from the AC power source as long as it is connected to the wall outlet, even if this unit itself is turned off. This state is called the standby mode. In this mode, this unit is designed to consume a small amount of power.
FREQUENCY STEP switch (China and General Models only)
Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch (located at the rear) according to the frequency spacing in your area. Before setting this switch, disconnect the AC power plug of this unit from the AC outlet.
For Canadian Customers
To prevent electric shock, match wide blade of plug to wide slot and fully insert.
This Class B digital apparatus complies with Canadian
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE STANDBY/ON SWITCH IS PRESSED;
The IMPEDANCE SELECTOR switch may not be set to either end. If so, set the switch to either end when this unit is in the standby mode.
IMPEDANCE SELECTOR
IMPEDANCE SELECTOR
REAR | SET BEFORE POWER ON | ||
REAR |
| : 6ΩMIN. /SPEAKER | |
(SURROUND) |
| ||
| CENTER |
| : 6ΩMIN. /SPEAKER |
| MAIN | A OR B: 4ΩMIN. /SPEAKER | |
|
| A | B: 8ΩMIN. /SPEAKER |
| REAR |
| : 8ΩMIN. /SPEAKER |
| CENTER |
| : 8ΩMIN. /SPEAKER |
| MAIN | A OR B: 8ΩMIN. /SPEAKER | |
|
| A | B:I6ΩMIN. /SPEAKER |
AC OUTLETS
SWITCHED
I20V 60Hz
I00W MAX. TOTAL
(U.S.A. model)
2