ADVANCED FEATURES

8.DTS SET

LFE LEVEL [Adjusting the output level at the LFE (low frequency effect) channel]

●

Control range: –10 dB to 10 dB

Adjusts the output level at the LFE (low frequency effect)

 

Preset value: 0 dB

channel. If the LFE signals are mixed with signals of other

●

This adjustment is effective only when DTS is decoded and

channels and they are output from the same speakers, the ratio

of LFE signals to other signals can be adjusted. (Refer to page 5

 

the signals of the selected source encoded with DTS

 

for details about the LFE channel.)

 

contain LFE signals.

 

 

9. CENTER DELAY [Adjusting the delay of center sounds (dialog etc.)]

English

●

●

Control range: 0 ms to 5 ms (in 1 ms step)

Preset value: 0 ms

This adjustment is effective only when Dolby Digital or DTS is decoded and the signals of the selected source encoded with Dolby Digital or DTS contain center channel signals.

Adjusts the delay between the main sounds (at the main channels) and dialog etc. (at the center channel).

The larger the value, the later the dialog etc. is generated.

In your audio system, the distance from the center speaker to your listening position may be shorter than the distance from the left or right main speaker to your listening position. In that case, sounds from the left main, center and right main speakers can reach your listening position at the same time by delaying the sound from the center speaker.

10. PARAMETER INI (Initializing parameters on a DSP program)

You can initialize all parameter settings on a DSP program. Note that some DSP programs have two subprograms; all parameters on both subprograms are initialized by this operation.

Initializing method

Use the remote controller for the operation.

A program number whose parameters has been changed is marked with “*”. First press the DSP key, and then press a DSP program selector key which corresponds to the program number whose parameters you want to initialize. When initialized, the “*” mark will disappear.

Note

When the selector dial of the remote controller is set at “DSP”, simply press the corresponding DSP program selector key.

53