115
Performance Mode
MIX Level
You can set output level, pan, effect send and other
parameters for each Part. This is useful when setting
up the levels of each Part in a mix.
■Vol (Volume)
Set the output level of the Part.
❏Settings: 0 ~ 127
■Pan
Set the stereo pan position of the Part.
❏Settings: L63 (Left) ~ C (Center) ~ R63 (Right)
■RevSend (Reverb Send)
Set the Send level of the signal sent from Insertion
Effect 1/2 (or the bypassed signal) to the Reverb
effect.
❏Settings: 0 ~ 127
■ChoSend (Chorus Send)
Set the Send level of the signal sent from Insertion
Effect 1/2 (or the bypassed signal) to the Chorus
effect.
❏Settings: 0 ~ 127
Part Tone
You can set Filter, Envelope Generator and other
parameters controlling the tonal characteristics of each
Part. The following four screens are available.
TON Filter (Tone Filter)
TON EG (Tone Envelope Generator)
TON Portamento (Tone Portamento)
TON Other (Tone Other)
TON Filter (Tone Filter)
You can use filters to adjust the tone of each Part. If
the filter is an LPF and HPF combination, the Cutoff
parameter applies to the LPF. These parameters are
also available in the Common Quick Edit screens.
Details about the Filter are given on Page 78.
■Cutoff
Raise or lower the Cutoff frequency for each
Element of a Part.
For each Element, if a combined Low Pass and High
Pass Filter is being used, this parameter adjusts the
Cutoff frequency of the Low Pass Filter.
❏Settings: -64 ~ 0 ~ +63
TONíFilter) Cutoff Reso
Part01 +63 +63
MIXíLevel) Vol Pan RevSend ChoSend
Part01 127 C 64 0
■Reso (Resonance)
Set the amount of Resonance (harmonic emphasis)
applied to the signal at the Cutoff frequency. This
adds further character to the sound.
❏Settings: -64 ~ 0 ~ +63
TON EG (Tone Envelope Generator)
You can set EG (Envelope Generator) parameters for
each Part. There are four parameters governing the
transition in output level from the moment a note is
pressed on the keyboard to the moment it is released or
the point at which the output level has faded to zero.
For more information, refer to a diagram that illustrate the
concept of Envelope Generator, which you can find in Voice
Edit Mode sections.
Part 1 to 16
Plug-in Part
Multi Plug-in Part
Drum Voice Part
■Attack
Set the transition time from the moment a key on
the keyboard is pressed to the point at which the
output level of the Part reaches its peak. A positive
value will lengthen the transition time and a
negative value will shorten it.
❏Settings: -64 ~ 0 ~ +63
■Decay
Set the transition time from the point at which the
output level of the Part reaches its peak to the point at
which it levels off. A positive value will lengthen the
transition time and a negative value will shorten it.
❏Settings: -64 ~ 0~ +63
■Sustain
Set the output level of the Part maintained while the
key on the keyboard is being held down.
This parameter is not available for Plug-in or Drum
Voice Parts.
❏Settings: -64 ~ 0 ~ +63
TONíEG) Attack Decay
Part10 + 0 + 0
TONíEG) Attack Decay Release
PartPL + 0 + 0 + 0
TONíEG) Attack Decay Sustain Release
Part01 + 0 + 0 + 0 + 0