7
English
2Position the speaker on the wall where you
want to hang it, and use a pencil to mark the
two hole positions.
3Screw two #8 screws into the wall, leaving a
5 mm gap to accept the keyhole slots.
4Thread the speaker cord around the strain-
relief guide and out through the slot at the
front of the speaker stand, as shown.
5Fit the speaker stand onto the screws and
push it down so that the screw heads sit
correctly in the keyhole slots.
Cautions:
•Each satellite speaker weighs 0.4 kg. Heed the following
cautions to ensure that the speakers do not fall and cause
damage or injury.
• Once the satellite speakers have been mounted on the
wall, check each speaker to ensure that there’s no possi-
bility of it falling. Yamaha cannot be held responsible for
any damage or injury caused by falling speakers.
• If you have hollow walls, make sure that the screws go
into the studs. If there are no studs, or the walls are solid,
use suitable wall anchors.
•Use 1-inch #8 screws (4 mm shank diameter) with a head
diameter of 8 mm or less.
• Do not use nails or double-sided tape to mount the
speakers.
• Use cord clips to secure the speaker cords to the wall.
■Securing the Center Speaker to Your TV
To prevent the center speaker from slipping, you can secure
it to your TV by using the fastener provided. You must
remove its stand first.
Notes:
• Do not put the center speaker on top of your TV if it
overhangs (i.e., the top of the TV is not deep enough).
•Do not put the center speaker on top of your TV if the top
is not level.
•Do not touch the adhesive side of the fastener after peel-
ing off the backing.
•Wipe the top of your TV before attaching the fastener.
1To remove the center speaker’s stand, using a
Phillips screwdriver, remove the screw and
washer at the back of the stand.
Keep the screw and washer for future use.
2Peel the backing off one side of the fastener,
and affix it to the top of your TV.
3Peel the backing off the other side of the
fastener, and affix the center speaker on top.
Note:
Although the speakers are magnetically shielded to prevent
interference, if the TV picture is distorted, try moving the
speakers away from your TV.
20 mm
minimum 5 mm gap
4 mm
diameter
40 mm
or
40 mm
Peel off the
backing
Bottom of speaker