Operation

6.Turn the main switch to “” (start), and hold it for a maximum of 5 seconds.

7.Immediately after the engine starts, re- lease the main switch and allow it to re-

turn to “” (on).

ECM00191

CAUTION:

●Never turn the main switch to “” (start) while the engine is running.

●Do not keep the starter motor turning for more than 5 seconds. If the starter motor is turned continuously for more than 5 seconds, the battery will be quickly discharged, thus making it im- possible to start the engine. The starter can also be damaged. If the engine will not start after 5 seconds of cranking, return the main switch to “” (on), wait 10 seconds, then crank the engine again.

EMU27670

Warming up engine

EMU27681

Choke start models

1.After starting the engine, allow it to idle for 3 minutes to warm up. Failure to do so will shorten engine life. Gradually re- turn the choke knob to its home position as the engine warms up.

2.Check for a steady flow of water from the

cooling water pilot hole.

ECM00511

CAUTION:

A continuous flow of water from the cooling water pilot hole shows that the water pump is pumping water through the cooling passages. If water is not flowing out of the hole at all times while the engine is running, overheating and serious damage could occur. Stop the engine and check whether the cooling water inlet on the lower case or the cooling water pilot hole is blocked. Consult your Yamaha dealer if the problem cannot be located and corrected.

ZMU03908

EMU27740

Shifting

EWM00180

WARNING

Before shifting, make sure there are no swimmers or obstacles in the water near you.

ECM00220

CAUTION:

To change the boat direction or shifting position from forward to reverse or vice- versa, first close the throttle so that the engine idles (or runs at low speeds).

32