Yamaha V150 Stopping engine, NOTE:, WARNING, Procedure, Forward (tiller handle and remote control models), Reverse (automatic reverse lock and power trim and tilt models)

Operation

EMU27764

Forward (tiller handle and remote control models)

Tiller handle models

1.Place the throttle grip in the fully closed position.

2.Move the gear shift lever quickly and firmly from neutral to forward.

Remote control models

1.Pull up the neutral interlock trigger (if equipped) and move the remote control lever quickly and firmly from neutral to forward.

F N

ZMU03406

EMU27785

Reverse (automatic reverse lock and power trim and tilt models)

EWM00190

WARNING

When operating in reverse, go slowly. Do not open the throttle more than half. Otherwise the boat could become unstable, which could result in loss of control and an accident.

Tiller handle models

1.Place the throttle grip in the fully closed position.

2.Move the gear shift lever quickly and firmly from neutral to reverse.

Remote control models

1.Pull up the neutral interlock trigger (if equipped) and move the remote control

lever quickly and firmly from neutral to reverse.

N R

ZMU03407

EMU27820

Stopping engine

Before stopping the engine, first let it cool off for a few minutes at idle or low speed. Stopping the engine immediately after operating at high speed is not recommended.

EMU27852

Procedure

1.Turn the main switch to “” (off).

2.After stopping the engine, disconnect the fuel line or close the fuel cock if there is a fuel joint or a fuel cock on the boat.

3.Tighten the air vent screw on the fuel tank cap (if equipped).

4.Remove the key if the boat will be left unattended.

NOTE:

The engine can also be stopped by pulling the lanyard and removing the clip from the

33