E
1.Put the watercraft on land in a horizontal position.
2.Remove the seat. (See page
3.Remove the flushing hose connector cap 1, and then insert the garden hose adapter 2 into the flushing hose con- nector 3 and turn it until it is securely connected.
4.Connect the garden hose adapter to a water tap using a hose.
NOTE:
The garden hose is not included and must be purchased separately.
5.Start the engine, and then immediately turn the water supply on until water flows out continually from the jet nozzle.
6.Run the engine at idling speed for about 3 minutes watching the engine condition. If the engine stops while flushing, turn the water supply off immediately and repeat the above steps.
7.Turn the water supply off, and then force the remaining water out from the cooling water passages by alternately squeezing and releasing the throttle lever for 10 to 15 seconds.
8.Stop the engine.
9.Remove the garden hose adapter and install the cap.