E

EJU21620

Lubrication

WARNING

Do not spray flammable rust inhibitor products on engine surfaces while the engine is hot. The sprayed substance or propellants could catch fire.

1.Remove the seat. (See page 2-5 for seat removal and installation procedures.)

2.Loosen the clamp screw 1 and discon- nect the air intake duct 2.

3.Spray a rust inhibitor such as Yamaha Stor-Rite Engine Fogging Oil into the intake opening 3 for 3 seconds.

4.Connect the air intake duct and tighten the clamp screw.

5.Start the engine in a well-ventilated area and let it run at idle for 15 seconds.

CAUTION:

Do not run the engine for more than 15 seconds. The engine could overheat.

6.Lubricate all cables such as the throttle and steering cables.

NOTE:

Use a Yamaha Power Cable Luber and Yamaha Lube-Zall to pressure lubricate the cables and purge out any moisture between the inner and outer cables.

7.Lubricate the areas of the watercraft specified under Lubrication points on page 4-18.

4-3