E

3.Select your four-letter code by pressing the “A/SET,” “B,” or “C” buttons in a desired sequence.

NOTE:

If you do not press a button for more than 10 seconds, the display automatically turns off. This cancels the process of setting a code.

4.After code setting is complete, the buzzer will sound 3 times and the display will show “SET.” Lastly, the display turns off and the warning light turns on again. After the meter has displayed this sequence, connect the blue connector again.

NOTE:

●Your own code is kept even if the battery terminal is disconnected.

●If you forget your own code, or if you want to change the code, do this initial setting procedure again from the beginning.

EJU01224

Selecting “PADLOC” mode

Selecting the desired mode can only be done after the initial setting has been done and while the display is not lit.

1.Press the “MODE” button until the meter displays the current mode, “START” or “LOCK.”

2.With “START” or “LOCK” displayed, press the “MODE” button continuously for about 3 seconds until the display changes to “COdE.”

2-22