E
1.Put the watercraft on land in a horizontal position.
2.Open the flushing hose connector cap 1, and then insert the garden hose adapter 2 into the flushing hose con- nector 3 and turn it until it is securely connected.
3.Connect the garden hose adapter to a water tap using a hose.
4.Start the engine, and then immediately turn the water supply on until water flows out continually from the cooling water pilot outlet.
5.Run the engine at idling speed for about 3 minutes watching the engine condition. If the engine stops while flushing, turn the water supply off immediately and repeat the above steps.
6.Turn the water supply off, and then force the remaining water out from the cooling
passages by running the engine at 4,000 r/min or less within 10 to
15 seconds.
7.Stop the engine.
8.Remove the garden hose adapter and secure the cap.