Yamaha YAS-70 owner manual Attaching the center system to a wall

Placing this system

■Attaching the center system to a wall

You can attach the center system to a wall using commercially available screws (#8, Diameter: 7.5 mm or more (9/32” or more)).

When installing the center system on a wall, all installation work must be performed by a qualified contractor or dealer personnel. The customer must never attempt to perform this installation work. Improper or inadequate installation could cause the center system to fall, resulting in personal injury.

1 Attach the supplied mounting template on a wall and then mark the holes of the mounting template.

Tapes or thumbtacks

Mark

2 Remove the mounting template and then install the commercially available screws at the marks.

Diameter:

7.5 mm or more (#8, 9/32” or more)

4 to 6 mm (3/16” to 1/4”)

Installing the cables above the center system

To pass the cables upward, you need to attach the spacers to make room on the back of the center system.

In step 2 of the left column;

2-a: Attach the supplied spacers to the rear panel of the center system using the supplied double-sided tapes. You can choose either the side A or the side B.

For narrow space	For wide space
Large double-	Small double-
sided tape	sided tape
Attach	Attach

y

To install the cables above the center system, refer to the right column.

3 Hang the center system on the screws using the holes on the back of the center system.

2-b: Remove the mounting template and then install the commercially available screws at the marks.

22 to 24 mm	34 to 36 mm
(7/7” to 15/16”)	(5/16” to 7/16”)

Notes

•The center system weighs about 4.5 kg (9 lbs. 15 oz.). To attach the center system to a wall using screws, the wall must be firm. Do not attach the center system to a wall that is made of weak materials such as plaster or veneered woods. Doing so may cause the center system to fall.

•Use commercially available screws that can endure weight enough.

•Make sure you use specified screws to attach the center system to a wall. Using clamps other than specified screws, such as short screws, nails, or two-sided tape, may cause the center system to fall.

•When connecting the center system, fix the speaker cables in place so that cables do not loosen. If your foot or hand accidentally gets caught on a loose speaker cable, the center system may fall.

•After attaching the center system, check that the center system is fixed securely. Yamaha will bear no responsibility for any accidents caused by improper installations.

8 En