Keyboard Stand Assembly

Keyboard Stand Assembly

CAUTION

•Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor- dance with the sequence given below.

•Assembly should be carried out by at least two persons.

•Assemble the stand on the flat floor surface.

•Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Use of incorrect screws can cause damage or malfunction of the product.

•Be sure to tighten up all screws upon completing assembly of each unit.

•To disassemble, reverse the assembly sequence given below.

Have a Phillips-head (+) screwdriver ready

Remove all parts from the package and make sure you have all of the items.

 

A

D

E

 

B

 

C

1. Attach (finger-tighten) C to D and E.

1-1Untie and straighten out the bundled pedal cord. Don’t discard the vinyl tie. You will need it later in step 6.

1-2Align D and E with each end of C.

1-3Attach D and E to C by finger-tightening the long screws 1 (6 ⋅ 20mm).

AC Power cord (YDP-160)

Bundled pedal cord inside

AC Power adaptor (YDP-140)

Assembly Parts

E

1-2

D

6 ⋅ 20 mm long screws ⋅4 1 4 ⋅ 20 mm tapping screws ⋅4 4

6 ⋅ 16 mm short screws ⋅4 2 Cord holders ⋅ 2

4 ⋅ 12 mm thin screws ⋅2 3

Headphone hanger set (YDP-160 only)

4 ⋅ 10 mm thin screws ⋅2 5 Headphone hanger

C

1-3

1-1

33

YDP-160/140Owner’s Manual 35