Others
In case of difficulty
If operation freezes, the screen goes black or the unit should otherwise not function properly, try turning the power off then back on. Alternatively, try the following methods in the order listed until the unit returns to normal playback mode.
1)Turn the car’s ignition OFF and back ON again.
2)Press the RESET button on the face of the unit
This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult a professional mobile video installer.
| Symptom | Cause | Remedy |
|
|
|
|
|
|
| Unit does not | Fuse is blown. | Replace with a fuse of the specified capacity. |
|
| operate. |
|
|
|
| Monitor’s power is not turn on. | Turn on the monitor’s power |
| |
|
| Condensation | Wait a while(about 1 hour) for the condensation |
|
|
|
| to dry. |
|
| Operation is | Remote control unit’s | Replace the remote control unit’s battery with |
|
| unstable. | battery is worn. | new one. |
|
|
| Remote control sensor or | Clean the sensor or transmitter. |
|
|
| transmitter is dirty. |
|
|
| No picture is | Monitor’s mode is not | Switch to the mode you want to see. |
|
| produced. | switched to the mode you |
|
|
|
| want to see. |
|
|
| Playback does | Disc is loaded | Check the disc and load it with the labeled side |
|
| not start. |
| facing upward. |
|
|
| Disc is dirty. | Clean the disc. |
|
|
| A disc not able to playback | Check if the disc is able to be played back. |
|
|
| with this unit is loaded. |
|
|
|
| Parental lock is set. | Cancel the parental lock or change the rating |
|
|
|
| level. |
|
|
|
|
|
|
| Picture is | Disc is being | The picture may be slightly disturbed, but this |
|
| unclear or noisy | or | is normal. |
|
|
| Vehicle’s battery power is | Check the battery power and wiring. |
|
|
| weak. | The unit may malfunction if the battery power is |
|
|
|
| under 10.8 volts with a load applied. |
|
|
| Monitor’s fluorescent tube is | Replace the monitor’s fluorescent tube. |
|
|
| worn. |
| |
|
|
|
| |
| Image stops | Disc is scratched. | Replaced with a |
|
| sometimes. |
| ||
|
|
|
| |
| No disc | No disc is loaded. | Load a disc. |
|
|
| Disc is dirty. | Clean the disc. |
|
| Not valid | Remote control operation | For some discs or playing modes, certain |
|
|
| is not possible. | operations are not possible. This not a |
|
|
|
| malfunction. |
|
| VIDEO SIGNAL | PAL( or NTSC) disc is loaded. | Change the TV TYPE of the unit(see SET UP). |
|
| SYSTEM IS NOT |
| ||
|
|
|
| |
| CORRECT |
|
|
|
|
|
|
|
|
|
|
| According to the connection, set ANALOG for |
|
| No sound | Select the wrong Audio Out | using audio cable, set SPDIF/RAM/PCM for |
|
| using coaxial cable. See page 7,8 and 19. |
| ||
|
|
|
|
24
