MAINTENANCE AND REPAIR INSTRUCTIONS

7.Insert the end of the line into one of the two holding slots (Fig. 14).

Holding

Slot

Fig. 14

8.Insert the end of the line through the eyelet in the outer spool (Fig. 15).

Fig. 15

9. Place inner reel and spring inside the outer spool.

NOTE: The spring must be assembled on the inner reel before reassembling the bump head.

10.Hold the inner reel in place, grasp the line end and pull firmly to release the line from the holding slot in the inner reel (Fig. 16).

11.Install the bump head cover over the inner reel. Align the tabs on the cover with the slots in the outer spool and press the cover evenly down until it snaps into place.

NOTE: Make sure the bump head cover tabs snap into place or the inner reel will come out during operation.

INSTALLING A PREWOUND REEL

Always use genuine replacement line. Using larger line then the specified may make the motor overheat or fail.

1.Remove the bump head cover by pressing in both bump head cover tabs visible on either side of the bump head outer spool (Fig. 11).

NOTE: The spring will push the cover up when the tabs release.

2.Remove the old inner reel and spring from the outer spool (Fig. 11).

3.Remove the spring from the old inner reel (Fig. 11).

4.Use a clean cloth to wipe the inner surface of the outer spool.

5.Insert the end of the line, on the prewound reel, through the eyelet in the outer spool (Fig. 15).

6.Place inner reel and spring inside the outer spool.

NOTE: The spring must be assembled on the inner reel before reassembling the bump head.

7.Hold the inner reel in place, grasp the line end and pull firmly to release the line from the holding slot in the inner reel (Fig. 16).

8.Install the bump head cover over the inner reel. Align the tabs on the cover with the slots in the outer spool and press the cover evenly down until it snaps into place.

NOTE: Make sure the bump head cover tabs snap into place or the inner reel will come out during operation.

Fig. 16

12