RULES FOR SAFE OPERATION
•Before using the charging stand, read all instructions and cautions in this manual, as well as on the charging stand, and on the unit.
•Do not expose charger to rain or snow.
•To reduce risk of injury, charge only sealed
•To reduce risk of damage to charger body and cord, pull it by the charger body (not the cord) when disconnecting the charger.
•Make sure the charger cord is located in an area where it will not be stepped on, tripped over or otherwise subjected to damage or stress.
•Do not operate the charger with a damaged cord or plug. If damaged, replaced the charger immediately.
•Do not operate charger if it has received a sharp blow, been dropped or has been damaged in any way. If the charger case is damaged, replace the charger.
•Do not disassemble the charger. The charger is not serviceable; disassembly may result in a electric shock or fire.
•To reduce the risk of electric shock, unplug the charger from the outlet before you clean or service the unit.
•Do not use the charger outdoors.
•Use only the following type and size battery: 12 volt DC, sealed
•Do not dispose of batteries in fire. The cell may explode. Batteries should be recycled. Consult your local waste authority for information regarding available recycling and/or disposal options.
•Exercise care when handling the batteries. Be careful and avoid shorting the battery with conducting materials like rings, bracelets and keys. The battery or conductor may overheat and cause burns.
•Charge the battery in a location where the temperature is between 50˚F (10˚C) and 100˚F (38˚C).
•Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.
WHILE OPERATING•Wear safety glasses or goggles that are marked as meeting ANSI
•Wear heavy, long pants, boots and gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair above shoulder level.
•The cutting attachment shield must always be in place while operating the unit. Do not operate unit without the trimming lines extended, and the proper line installed. Do not extend the trimming line beyond the length of the shield.
•Adjust the
•Be sure the cutting attachment is not in contact with anything before starting the unit.
•Use the unit only in daylight or good artificial light.
•Avoid accidental starting. Do not carry around a unit with your finger on the trigger switch.
•Use the right tool. Only use this tool for the purpose intended.
•Do not overreach. Always keep proper footing and balance.
Always hold the unit with both hands when operating. Keep a firm grip on both the battery housing grip and the
•Keep hands, face and feet at a distance from all moving parts. Do not touch or try to stop the cutting attachment when it is rotating.
•Do not operate the motor faster than the speed needed to cut, trim or edge. Do not run the motor at high speed when you are not cutting.
•Always stop the motor when cutting is delayed or when walking from one cutting location to another.
•If you strike or become entangled with a foreign object, stop the motor immediately and check for damage. Do not operate before repairing damage. Do not operate the unit with loose or damaged parts.
•Release the trigger, ensure the
•Use only original equipment manufacturer replacement parts when servicing this unit. These parts are available from your authorized service dealer. Do not use unauthorized parts, accessories or attachments. Using unauthorized parts may lead to serious injury, damage to the unit and a voided warranty.
•Keep the unit clean of vegetation and other materials. They may become lodged between the cutting attachment and shield.
OTHER SAFETY WARNINGS•Disconnect the unit from the power supply when it is idle, when you are storing or transporting it, when you are servicing it, and when you are changing attachments.
•Store the unit in a dry area, locked up to prevent unauthorized use or damage, and stored in a high place out of the reach of children.
•Never douse or squirt the unit with water or any other liquid. Keep handles dry, clean and free from debris. Clean after each use. See the Cleaning and Storage instructions.
•Keep these instructions. Refer to them often and use them to instruct other users. If you loan someone this unit, also loan them these instructions.
SAVE THESE INSTRUCTIONS
4