ASSEMBLY INSTRUCTIONS

INSTALL AND ADJUST THE D-HANDLE

1.Push the D-handle down onto the shaft housing and push it on the boom (Fig. 1). The squared bolt hole in the handle is to the right.

Fig. 1

2.Insert the shoulder bolt into the squared hole in the handle and push through. On the left side of the handle, place the washer on the bolt, then screw the wing nut onto the bolt. Do not tighten until you make the handle adjustment.

3.Rotate the D-handle to place the grip above the top of the shaft housing. Place it a minimum of 6 inches (15.24 cm) from the end of the housing.

4.While holding the unit in the operating position (Fig. 2), position the D-handle to the location that provides you the best grip.

5.Tighten the wing nut until the D-handle is secure.

MOUNTING THE CHARGING STATION

NOTE: Mount the charging unit and allow the unit to charge for at least 36 hours prior to first use.

This unit may stay on the charging station continuously without overcharging. Place the charging station where the unit is intended to be stored. This should be a cool, dry and well ventilated place, where the unit can be locked-up and out of the reach of children.

The unit should be stored and charged in a location where the temperature is between 50˚F (10˚C) and 100˚F (38˚C).

1.Locate a place for the charging station near a wall outlet and high enough to keep the unit off the floor.

2.Locate the wall stud and mount the charging station to the wall using the three (3) screws provided

(Fig 3). Make sure that the screws enter the wall stud to provide a secure mount.

Charging Station

 

Screws

 

 

Wall

Wall Outlet

Stud

Charger

Cord Wrap

Charging

Indicator Light

Fig. 3

CAUTION: To prevent injury or damage to the unit,

the charging station must be mounted securely to the wall.

3.Plug the charger into the wall outlet and wind any excess wire onto the cord wrap on the charging station (Fig. 3).

Fig. 2

7