7. ASH REMOVAL
Warning: Ash can remain hot long after appliance has been in use.
7.1Wood:
—Open Doors (see Section 1.14)
—Leave a layer of ash to start the new fire on. Wood burns best on a bed of ash (approx. 25mm (1") deep).
—Remove ash with a small shovel and place into
a Stovax Ash Caddy (Stovax Part No. 4227) or other suitable container.
Do not place hot ash in any container made from plastic or any other combustible material.
—De-ash at least once a week.
7.2Multi-fuel:
De-ash the appliance before filling with new fuel. Do not allow ash to build up on the underside of the grate as this can cause premature failure.
—Insert the Riddling Tool into the socket as shown in Diagram 8.
8
Push/Pull to
operate
PR8874
—Rotate the Riddling Tool backward and forward
3 or 4 times to remove the ash. Do not force the handle beyond its natural stop point. The ash will fall into the ashpan.
—Open doors.
Warning: Ash can remain hot long after appliance has been in use.
—Remove front plate (see Diagram 9).
—Using gloves, carefully remove ashpan (see Diagram 9).
—Place the ash into a Stovax Ash Caddy (Stovax Part No. 4227) or other suitable container.
—Check and remove ash as often as required when burning solid fuel.
—De-ash at least once a week.
—Do not place hot ash in a container made from plastic or any other combustible material.
8.Wood burning tray
8.1In order to burn wood continuously in this appliance a Wood Burning Tray should be fitted (see Diagram 10).
10
PR8882
8.2Remove the multi-fuel grate from the appliance (see Installation Instructions, Section 4).
8.2To fit the Wood Burning Tray:
—Remove the log bar and ashlip,
—Hold the tray flat with the front edge pointing forwards (see Diagram 10).
—Tilt diagonally and insert through the front of the stove (see Diagram 11).
