Indoor Blower Motor and Drive - The indoor blower motor fea- tures ball bearings that do not require periodic lubrication. However, if the motor has grease
fittings, periodic lubrication of the motor bearings can extend the life of components but is optional.
If desired, every three years, using a low pressure grease gun, pump grease into the bearing grease fitting until grease just begins to show at the seals. Do not over lubricate. Use any lithium base grease recommended for ball bearing ser- vice.
Damage can occur if the bearings are overlubricated. Use grease sparingly.
REGISTERS
Supply and return air registers must be open when the unit is in operation. Obstructions must not be allowed to block air- flow in or out of the registers.
CONDENSER COIL
An annual check and cleaning, if necessary, of the outdoor coil should be done. Cleaning should be as often as neces- sary to keep the coil clean. Clean any debris and dirt from the outside coil face with a brush being careful not to damage the fins. If extremely dirty, a hose can be used to wash the coil from the inside out while brushing a soapy solution on the outside.
TROUBLESHOOTING
BEFORE CALLING A SERVICE TECHNICIAN:
A.Check thermostat setting and insure thermostat is calling for heat or cooling.
B.Check thermostat for lint, etc.
C.Check fuses or circuit breakers.
D.Check filters for excessive dust accumulation.
OWNER please have your installer fill in the following information immediately after unit has been installed and is properly operating.
Installed by __________________________________________________________________________________
Installer’s Address ____________________________________________________________________________
Installation Date ______________________________________________________________________________
Owner’s Name _______________________________________________________________________________
Owner’s Address _____________________________________________________________________________
Equipment installed at (address) _________________________________________________________________
Model Number ____________________________________ Serial Number _____________________________
Distributor from whom the equipment was purchased _________________________________________________
The owner should keep this information in a place where it can be found if needed for warranty purposes.
Subject to change without notice. Printed in U.S.A. | |
Copyright © 2011 by Johnson Controls, Inc. All rights reserved. | Supersedes: |
|
|
|
|
Johnson Controls Unitary Products
5005 York Drive
