035-16328-Ray002C(0902).
LA, CAUTION]
FURNACE SEATED AGAINST THE LOCATOR BRACKET
\ SECUREFURNACE TO FLOOR WITH TWO NAILS OR SCREWS.
The inner flue pipe must be present.
It is mandatory that the combustion air pipe and flue pipe assembly be fully engaged. The com-
bustion air pipe MUST be securely fastened to the furnace with a sheet metal screw in the hole
provided.
Use a 1/2" blunt or sharp end sheet metal screw to fasten roof jack combustionair pipe to furnace combustion air colla_ Screw hole is provided in the pipe and collar Excessively long screws may extend to flue pipe and puncture it. Screws are not to exceed 1 1/2"in length.
| NOTE: Combustion air tube and flue pipe are part of the |
FIGURE 13 : Installation of Furnace | same assembly. Only the combustion air tube need be fas- |
| tened to the furnace. |
INSTALLATION OF THE FURNACE
Remove the front panels and set the fumaca onto the duct connector. Slide it back until the rear of the unit engages the Iocator bracket.
2.Secure the front of the furnace with two screws at the mounting holes provided.
3.Secure the top of the furnace to a structural member using screw through the strap at the back of the furnace. Strap may be moved to any of the holes located along the top back of the furnace. Installer may provide an
equivalent method, such as screws through the casing side.
1.Check to be certain that the flue pipe and combustion air tube are present.
2.Pull the telescoping flue tube and combustion air tube assembly down from the roof jack. Slide the flue tube/ combustion air tube assembly down firmly over the fur- nace flue outlet and combustion air cellar. Insure that the back, side and front of combustion air tube collar is fully
engaged and is in contact with gasket, Fasten the com- bustion air tube to the furnace combustion air collar
usinga 1/2 inchsheet metal screw. (Screw hole provided in combustionair tube and fumaca combustionair collar.
See Figure 14.
COMBUSTION
SECURE STRAP
TO WALL_
It is mandatory that the combustion air and flue tube assembly be fully engaged at back sides and front, and combustion air tube securely fastened to the fumace with a sheet metal screw in the screw hole provided,
COMBUSTION
FRONT OF |
|
FURNACE | #8 OR #10 SCREW RECOMMENDED |
|
FIGURE 14 : Connecting Roof JAck to Furnace
Unitary Products Group | 11 |
