GENERAL INFORMATION
NOTE: The words "Shall" or "Must" indicate a requirement which is essential to satisfactory and safe product perfor- mance.
The words "Should" or "May" indicate a recommendation or advice which is not essential and not required but which may be useful or helpful.
IMPORTANT - These instructions are primarily intended to assist qualified individuals experienced in the proper installa- tion of heating and/or air conditioning appliances. Some local codes require licensed installation service personnel for this type of equipment. Read all instructions carefully before start- ing the installation.
II _WARNING
Improper installation may damage equipment, can create a shook hazard, and will void the war- ran_
The furnace shall be installed so the electrical components are protected from water
The furnace is not to be used for temporary heat- ing of buildings or structures under construction.
Do not test the fuel system at more than 14 inches water column after fumace has been con- nected to the fuel line. Such testing may void the warren_ Any test run above 14 inches water col- umn may damage the furnace control valve
which could cause an explosion, fire, or asphyxi- ation.
INSTALLATION STANDARDS
CODECOMPLIANCE
The installer must comply with all local codes and regulations which govern the installation of this appliance. Local codes and regulations shall take precedent over these regulations where applicable. In lieu of local codes, the appliance shall
be installed in accordance with one or more of the following standards.
Manufactured homes in the U.S.A.:
1, Federal Manufactured Home Construction & Safety Standard (HU.D. Title 24, Part 3280),
2.National Fuel Gas Code
3.National Electrical Code (NFPA 70).
Manufactured homes in Canada:
1, Natural Gas and Propane Installation Code (CAN/CSA
B149,1).
2.Canadian Electrical Code, Part 1 (CSA C22,1)
Recreational Vehicles in U.S.A.:
1.Standard on Recreational Vehicles (NFPA 1192, formerly NFPA 501C).
2.National Electrical Code (NFPA 70).
Recreational Vehicles in Canada:
1, Unit installationshall comply with current CSA standard
2.Unit electrical widng and grounding shall comply with current CSA standard C22.2
- Electrical Requirements for recreational vehicles.
HIGH ALTITUDE INSTALLATION
For elevation above 2,000 feet, derate furnace input 4% for each 1,000 feet of elevation above sea level. Derating is
accomplished by reducing the orifice size. See Derating Chart for orifice size.
In Canada, for elevations from 2000 to 4500 feet derate by reducing gas manifold pressure to 3.0" W.C. for natural gas and 9.0" W.C. for LP gas.
IA CAUTIONj
•Never attempt to alter or modify this furnace or any of its components.
•Never attempt to repair damaged or inoperable components. Such action could cause unsafe opera- tion, explosion, fire and/or asphyxiation.
•If a malfunction has occurred, or if you feel that the furnace is not operating as it should, contact a quali- fied service agency or gas utility for assistance.
MINIMUM FURNACE CLEARANCES
Access for servicing is an important factor in the location of any furnace. A minimum of 24 inches should be provided in front of the furnace for access to the heating elements and controls. This access may be provided by a closet door or by locating the furnace 24 inches from a facing wall or partition.
These furnaces are design certified for the following minimum clearances from combustible material in alcove or closet instanation
Table 1: MINIMUM CLEARANCES
CLOSETALCOVE
BACK0"0"
SIDES0"0"
FRONT6"24"
TOP2"2"
ROOF JACK | 0" | 0" |
DUCT0"O"
Unitary Products Group | 3 |
