REQUIRED TOOLS
1. | Screw driver | 9. | Manifold gauge |
2. | Hexagonal wrench | 10. | Gas leak detector |
3. | Torque wrench | 11. | Vacuum pump |
4. | Spanner | 12. | Pipe clamp |
5. | Reamer | 13. | Pipe cutter |
6. | Hole core drill | 14. | Flare tool set |
7. | Tape measure | 15. | Electrical circuit tester |
8.Thermometer
EXTENDED PARTS
1.Refrigarant Pipe
Models | 24 | ||
|
|
|
|
Liquid size | 1/4 inch | 1/4 inch | 3/8 inch |
|
|
|
|
Gas size | 3/8 inch | 1/2 inch | 5/8 inch |
2.Pipe insulation material (Polyethylene foam 9 mm thick)
3.Vinyl tape
4.Putty
SAFETY PRECAUTIONS
•Please read this installation manual carefully before starting installation of the unit.
•This air conditioning system contains refrigerant under pressure, rotating parts and electrical connection which may be dangerous and can cause injury. Installation and maintenance of this air conditioning system should only be carried out by trained and qualified personnel.
•After unpacking, please check the unit carefully for possible damage.
•Before undertaking any work on the unit, make sure that the power supply has been disconnected.
WARNING & CAUTIONS
INSTALLATION
Do not store or unpack the unit in a wet area or expose |
| Do not install in a place where flammable gas may |
to rain or water. |
| leak. |
|
|
|
It may cause the unit to short circuit and may result electric |
| It may cause fire. |
shocks or fire. |
|
|
|
|
|
Do not conduct installation in wet area or in the rain. |
| This system is designed for domestic or residential |
|
| use only. |
|
|
|
It is a high risk to cause the electrical shocks. | If used in certain environments, such as a manufacturing |
| workplace, the equipment may not function efficiently. |
ENGLISH 3
EN
J199.pmd | 3 | 31/03/2005, 9:53 PM |
