PART NAMES
INDOOR UNIT
2 1
3 10
4 | 7 | 8 | 6 |
| 5 |
|
|
9
OUTDOOR UNIT
12
13
DISPLAY PANEL
Signal receptor
AUTO DEFROST |
|
|
| OPERATION TIMER |
|
|
| ||
|
|
|
|
|
1 | 2 | 3 | 4 | 5 |
■INDOOR & OUTDOOR UNIT
1 | Front panel | 8 | Remote controller signal |
2 | Air inlet |
| receiver |
3 | Air filter | 9 | Remote controller |
4 | Air outlet | 0 | Manual control button |
5Horizontal air flow grille - Connecting pipe, drain hose
6Vertical air flow louver = Air inlet (side and rear)
7 Display panel | ~ Air outlet |
Bio Filter
The perfection of MasterGold begins with the innovative Bio Screen for purifying air. This Bio Screen works in a twofold manner
11to give you the maximum effect of purification and dust elimination.
■DISPLAY PANEL
1AUTO indicator
This indicator illuminates when the air conditioner is in AUTO
operation.
2DEFROST indicator (For Cooling & Heating models only) This indicator illuminates when the air conditioner starts defrosting automatically or when the warm air control feature is
activated in heating operation.
3TEMPERATURE indicator
Displays the temperature settings when the air conditioner is
operational.
4OPERATION indicator
This indicator flashes after power is on and illuminates when
the unit is in operation.
5TIMER indicator
This indicator illuminates when TIMER is set ON/OFF.
NOTE
All the pictures in this manual are for explanation purpose only. They may be slightly different from the air conditioner your purchased. The actual shape shall prevail.
OPERATING TEMPERATURE
Mode | Cooling | Heating | Drying | |
Temperature | operation | operation | operation | |
Room temperature | ||||
Outdoor | ||||
temperature | ||||
|
|
| ||
|
|
|
|
CAUTIONS
1.If air conditioner is used outside of the above conditions, certain safety protection features may come into operation cause the unit to function abnormally.
2.Room relative humidity less than 80%. If the air conditioner oper- ates in excess of this figure, the surface of the air conditioner may attract condensation. Please sets the vertical air flow louver to its maximum angle (Vertically to the floor), and set HIGH fan mode.
3.Optimum performance will be achieved within these operating temperature.
J199.pmd | 4 | 31/03/2005, 9:53 PM |