York MLCA-MLHA-07-24 owner manual Wiring, Piping, Drain hose

MODEL 24

Above 150mm from the ceiling

Hooked Part	Hooked Part	Hooked Part
	1080
		108
432	432
		22
Above 120mm from		Above 120mm from
the wall
		the wall
330

58			A	Right
	95	95	58
50			50
	115	115
Pipe hole	465	465	Pipe hole		Right
		Indoor Unit Outline		B

		D Right
CAUTION	C Right	F Left

• Be careful when handling the sharp edge of the mounting plate.

E Rear Bottom

■Wiring

• This indoor unit is ready for connection to the outdoor unit.

CAUTIONS

•Never modify the unit by removing any of the safety guards or by passing any of the safety interlock swithces.

•Connect the interconnecting cable correctly and connect the connecting cable to terminal as identified with their respective marking.

•Do not damage the conductor core or inner insulation of power supply cables and do not deform or crush the cables.

■Piping

The auxiliary piping can be connected in the diections shownF the above diagram. To connect in the D, Eand

direction, pipes will need to be extended.

CAUTIONS

•Bend pipes carefully to avoid flattening or obstructing them if the pipes are bent incorrectly, the indoor unit may be unstable on the wall.

•Carefully arrange pipes so that pipes do not stick out of the rear plate of the indoor unit.

■ Drain hose For right and right rear piping

• Drain hose is flexible and can be routed to suit various piping arrangements. The drain line must include elbow trap (U bend). Connect a plastic condensate pipe with an internal diameter of 12 mm.

EN

Drain hose

Drain cap

Verification of condensate water drainage:

Fill the drain pan with water and observe evacuation.

Note: Do not put the drain hose end into water.

• The drain hose can be connected to the left or the right side.

For left and left rear piping

Drain hose

Drain cap

ENGLISH 9

J199.pmd 9 31/03/2005, 9:53 PM