Manuals / Z-Com / Computer Equipment / Network Card

Z-Com manual Build the debugging tool, make clean make XG-762NREVB=0 make XG-762NREVB=0 install

Models: XG-762N

1 17

Download 17 pages 51.72 Kb

Page 4

make clean

make clean

make XG-762NREV_B=0

make XG-762NREV_B=0 install

to install the driver.

2.4 Build the debugging tool

There are two debugging tools in this package, ¡°apdbg¡±and ¡°menudbg¡±.Run ¡°make debug¡±to compile them both. If you don¡¯t have the ncurse library, you may get some error messages while compiling menudbg. You can ignore it and get apdbg only.

4

Image 4

Z-Com manual Build the debugging tool, make clean make XG-762NREVB=0 make XG-762NREVB=0 install, to install the driver

Contents

The User Guide of XG-762N USB Linux Driver 1. Introduction 1.1 Requirements2.2 Build and install the driver 2.3 Install individual driver2. Building the device driver 2.1 Package Extractionmake clean make XG-762NREVB=0 make XG-762NREVB=0 install 2.4 Build the debugging toolto install the driver 3.3 Configure the Wireless settings 3. Getting Start3.1 Load the driver 3.2 Open the network interface3.4 Private commands powerrtsthreshold fragthreshold3.4.1 Set authentication type 3.4.6 Connect to the given Access Point3.4.2 Set preamble type 3.4.3 Get preamble type3.4.7 Dynamical Region SettingFor 802.11b/g only 3.4.8 Activate MIC Fail Counter Measure Feature3.5 Set up IP address 3.5.1 Fixed Setting3.5.2 Get IP setting from DHCP 3.5.3 Setting Access Point3.6.1 Setup the Linux wpa supplicant 3.6 Working with Linux WPA supplicantdescription , you can refer to the original sample configuration file After modifying, use the following command to setup WPA connection If the XG-762N is not open yet, please open it firstly by commandifconfig eth1 up IP address of the network interface Note23.7 Customization of VID/PID Table 3.8 Special Mode for Embedded Station Chariot TestThe command to specify association address is very simple ifconfig ethX downifconfig ethX hw ether 01XXXXXXXXXX ifconfig ethX up address of Station different4.1 Enable Burst Mode 4. Turbo Mode4.2 Large Packet mode Page 5. Conclusion